From: Kevin Hilman <khilman@xxxxxx> The runtime PM framework assumes that the hardware state of devices when initialized is disabled. For all omap_devices, we idle/disable device by default. However, the console uart uses a "no idle" option during omap_device init in order to allow earlyprintk usage to work seamlessly during boot. Because the hardware is left partially enabled after init (whatever the bootloader settings were), the omap_device should later be fully initialized (including mux) and the runtime PM framework should be told that the device is active, and not disabled so that the hardware state is in sync with runtime PM state. To fix, after the device has been created/registered, call omap_device_enable() to finialize init and use pm_runtime_set_active() to tell the runtime PM core the device is enabled. Tested on 2420/n810, 3530/Overo, 3530/Beagle, 3730/OveroSTORM, 3730/Beagle-xM, 4460/PandaES. Reported-by: Paul Walmsley <paul@xxxxxxxxx> Suggested-by: Russell King <rmk+kernel@xxxxxxxxxxxxxxxx> Cc: Felipe Balbi <balbi@xxxxxx> Cc: Sourav Poddar <sourav.poddar@xxxxxx> Signed-off-by: Kevin Hilman <khilman@xxxxxx> --- Applies against v3.7-rc1. Fix targetted for v3.7. I'm still not entirely sure why this has worked up to now on OMAP3/4 but not on OMAP2. Even so, this fix is needed for all platforms to ensure matching hardware state and runtime PM state. arch/arm/mach-omap2/serial.c | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/arch/arm/mach-omap2/serial.c b/arch/arm/mach-omap2/serial.c index 0405c81..37b5dbe 100644 --- a/arch/arm/mach-omap2/serial.c +++ b/arch/arm/mach-omap2/serial.c @@ -327,6 +327,11 @@ void __init omap_serial_init_port(struct omap_board_data *bdata, if ((console_uart_id == bdata->id) && no_console_suspend) omap_device_disable_idle_on_suspend(pdev); + if (console_uart_id == bdata->id) { + omap_device_enable(pdev); + pm_runtime_set_active(&pdev->dev); + } + oh->mux = omap_hwmod_mux_init(bdata->pads, bdata->pads_cnt); oh->dev_attr = uart; -- 1.7.9.2 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html