Hello,
I need to find a solution to control 2 bits in CONTROL_DEVCONF0 on OMAP2/3 for
McBSP1 CLKR/FSR signal routing.
In boards using McBSP1 we might need to change bit 3 and 4 based on the audio
setup (how the board has been wired).
So far I have come up with the following idea to handle to but not really sure
if it is the correct way (I have taken the idea from the arm/dts: Add AM33XX
basic pinctrl support series).
In .dtsi file of the SoC:
control_devconf0: pinmux@48002274 {
compatible = "pinctrl-single";
reg = <0x48002274 4>; /* Single register */
#address-cells = <1>;
#size-cells = <0>;
pinctrl-single,register-width = <32>;
pinctrl-single,function-mask = <0x5F>;
};
In the .dts file of the board which needs to change the CLKR/FSR configuration:
&control_devconf0 {
pinctrl-names = "default";
pinctrl-0 = <&mcbsp1_pins>;
mcbsp1_pins: pinmux_mcbsp1_pins {
pinctrl-single,pins = <0x00 0x18>; /* CLKR/FSR from CLKX/FSX
* pin */
};
};
Thanks for the help,
Péter
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
