According to the IGEPv2 Rev.C data-sheet the LAN9221i pin 14 (IRQ) is
connected to the OMAP3730 mcspi1_cs2 pin. Since this omap mux pin acts
as an IRQ line, it has to be configured as an input GPIO.
IGEPv2 platform code sets the smsc911x_cfg->gpio_irq to GPIO 176 but
since the mux pin default mode is MODE7 (safe_mode) the driver fails
when trying to register the IRQ with the following error message:
[ 1.994598] smsc911x: Driver version 2008-10-21
[ 3.704162] irq 272: nobody cared (try booting with the "irqpoll" option)
[ 3.711364] [<c001a114>] (unwind_backtrace+0x0/0xf0) from [<c009a0d4>] (__report_bad_irq+0x20/0xbc)
[ 3.720916] [<c009a0d4>] (__report_bad_irq+0x20/0xbc) from [<c009a41c>] (note_interrupt+0x1d8/0x238)
[ 3.730560] [<c009a41c>] (note_interrupt+0x1d8/0x238) from [<c0098234>] (handle_irq_event_percpu+0xc0/0x260)
[ 3.740936] [<c0098234>] (handle_irq_event_percpu+0xc0/0x260) from [<c0098410>] (handle_irq_event+0x3c/0x5c)
[ 3.751312] [<c0098410>] (handle_irq_event+0x3c/0x5c) from [<c009abe0>] (handle_level_irq+0xac/0x10c)
[ 3.761047] [<c009abe0>] (handle_level_irq+0xac/0x10c) from [<c0097a34>] (generic_handle_irq+0x30/0x48)
[ 3.770935] [<c0097a34>] (generic_handle_irq+0x30/0x48) from [<c02a6b74>] (gpio_irq_handler+0x180/0x1d4)
[ 3.780944] [<c02a6b74>] (gpio_irq_handler+0x180/0x1d4) from [<c0097a34>] (generic_handle_irq+0x30/0x48)
[ 3.790954] [<c0097a34>] (generic_handle_irq+0x30/0x48) from [<c0013e18>] (handle_IRQ+0x4c/0xac)
[ 3.800231] [<c0013e18>] (handle_IRQ+0x4c/0xac) from [<c000858c>] (omap3_intc_handle_irq+0x60/0x74)
[ 3.809783] [<c000858c>] (omap3_intc_handle_irq+0x60/0x74) from [<c04979e4>] (__irq_svc+0x44/0x60)
[ 3.819213] Exception stack(0xee42fde0 to 0xee42fe28)
[ 3.824554] fde0: 00000001 00000001 00000000 00000000 60000013 c06cce14 c06cce14 00000110
[ 3.833190] fe00: 00000000 c06ccdf4 60000013 ee41d000 fb058064 ee42fe28 c0089e08 c04976b4
[ 3.841796] fe20: 20000013 ffffffff
[ 3.845489] [<c04979e4>] (__irq_svc+0x44/0x60) from [<c04976b4>] (_raw_spin_unlock_irqrestore+0x34/0x44)
[ 3.855499] [<c04976b4>] (_raw_spin_unlock_irqrestore+0x34/0x44) from [<c0099744>] (__setup_irq+0x1b8/0x3f0)
[ 3.865875] [<c0099744>] (__setup_irq+0x1b8/0x3f0) from [<c0099a34>] (request_threaded_irq+0xb8/0x140)
[ 3.875701] [<c0099a34>] (request_threaded_irq+0xb8/0x140) from [<c0487950>] (smsc911x_drv_probe+0x75c/0x11a4)
[ 3.886260] [<c0487950>] (smsc911x_drv_probe+0x75c/0x11a4) from [<c02e9bcc>] (platform_drv_probe+0x18/0x1c)
[ 3.906707] [<c02e89b8>] (driver_probe_device+0x90/0x210) from [<c02e8bcc>] (__driver_attach+0x94/0x98)
[ 3.916625] [<c02e8bcc>] (__driver_attach+0x94/0x98) from [<c02e7298>] (bus_for_each_dev+0x50/0x7c)
[ 3.926177] [<c02e7298>] (bus_for_each_dev+0x50/0x7c) from [<c02e81d4>] (bus_add_driver+0x184/0x248)
[ 3.935821] [<c02e81d4>] (bus_add_driver+0x184/0x248) from [<c02e909c>] (driver_register+0x78/0x12c)
[ 3.945465] [<c02e909c>] (driver_register+0x78/0x12c) from [<c0008648>] (do_one_initcall+0x34/0x178)
[ 3.955108] [<c0008648>] (do_one_initcall+0x34/0x178) from [<c066e8f4>] (kernel_init+0xfc/0x1c0)
[ 3.964385] [<c066e8f4>] (kernel_init+0xfc/0x1c0) from [<c00140b0>] (kernel_thread_exit+0x0/0x8)
[ 3.973632] handlers:
[ 3.976043] [<c034e2cc>] smsc911x_irqhandler
[ 3.980560] Disabling IRQ #272
Signed-off-by: Javier Martinez Canillas <javier@xxxxxxxxxxxx>
---
arch/arm/mach-omap2/board-igep0020.c | 2 ++
1 files changed, 2 insertions(+), 0 deletions(-)
diff --git a/arch/arm/mach-omap2/board-igep0020.c b/arch/arm/mach-omap2/board-igep0020.c
index 7491529..2821448 100644
--- a/arch/arm/mach-omap2/board-igep0020.c
+++ b/arch/arm/mach-omap2/board-igep0020.c
@@ -554,6 +554,8 @@ static const struct usbhs_omap_board_data igep3_usbhs_bdata __initconst = {
#ifdef CONFIG_OMAP_MUX
static struct omap_board_mux board_mux[] __initdata = {
+ /* SMSC9221 LAN Controller ETH IRQ (GPIO_176) */
+ OMAP3_MUX(MCSPI1_CS2, OMAP_MUX_MODE4 | OMAP_PIN_INPUT),
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
#endif
--
1.7.7.6
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
