Shubhrajyoti D <shubhrajyoti@xxxxxx> writes: > From: Vikram Pandita <vikram.pandita@xxxxxx> > > In case a peripheral is driving SDA bus low (ie. a start condition), provide > a constant clock output using the test mode of the OMAP I2C controller to > try and clear the bus. Soft reset I2C controller after attempting the bus clear > to ensure that controller is in a good state. > > Based upon Vikram Pandita's patch from TI Android 3.0 kernel and modified for > mainline by Jon Hunter. > > A couple differences from the original patch ... > 1. Add a new function for bus clear > 2. Ensure that the CON.I2C_EN bit is set when using the SYSTEST feature to > output a permanent clock. This bit needs to be set and tpyically it would > be set by the unidle function but this is not the case for all OMAP > generations. > 3. Program the SYSTEST setting only the bits we care about. However, restore > SYSTEST registers to there original state as some OMAP generations do not > implement perform a soft-reset. > 4. Clear the CON register after performing the bus clear, so when we call the > init function the controller is disabled and the init function will > re-enable later. > > Cc: Kevin Hilman <khilman@xxxxxx> > Signed-off-by: Vikram Pandita <vikram.pandita@xxxxxx> > Signed-off-by: Jon Hunter <jon-hunter@xxxxxx> > Signed-off-by: Shubhrajyoti D <shubhrajyoti@xxxxxx> > --- > Original patch can be found here: > http://git.omapzoom.org/?p=kernel/omap.git;a=commit;h=a2ab04192ba25e60f95ba1ff3af5601a2d7b5bd1 > applies on Kevin's for_3.3/i2c/misc Please also explain how this was tested, and on what platforms. Thanks, Kevin -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
