On Wed, Dec 7, 2011 at 3:59 PM, Jarkko Nikula <jarkko.nikula@xxxxxxxxxx> wrote: > On 12/07/2011 03:39 PM, Felipe Balbi wrote: >>> >>> I'll try to flash a system to NAND, since I can't seem to just get the >>> MMC to work when the cover is open and the device is connected to the >>> jig to see if I can see something from serial console. >>> >>> You don't have any idea about what to try? >> >> >> you could cut the back cover so that it just fits the device on the jig >> (I did that to an old cover), then it works just fine :-) >> > You could also go without breaking the back cover by putting a magnet on top > the hal sensor (like tape a piece from a fridge magnet). See here the place: > > http://talk.maemo.org/showthread.php?p=1008775 > > Another option is to to set .gpio_cd = -EINVAL for external mmc in > arch/arm/mach-omap2/board-rx51-peripherals.c. Nice. That gpio_cd trick did it :) -- Felipe Contreras -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html