On 12/07/2011 03:39 PM, Felipe Balbi wrote:
I'll try to flash a system to NAND, since I can't seem to just get the
MMC to work when the cover is open and the device is connected to the
jig to see if I can see something from serial console.
You don't have any idea about what to try?
you could cut the back cover so that it just fits the device on the jig
(I did that to an old cover), then it works just fine :-)
You could also go without breaking the back cover by putting a magnet on
top the hal sensor (like tape a piece from a fridge magnet). See here
the place:
http://talk.maemo.org/showthread.php?p=1008775
Another option is to to set .gpio_cd = -EINVAL for external mmc in
arch/arm/mach-omap2/board-rx51-peripherals.c.
--
Jarkko
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
