Hi Tomi, On 17.11.2011 14:26, Tomi Valkeinen wrote: >> + .acbi = 0x0, >> + .acb = 0x28, > > You could just remove .acbi and .acb, I don't think they are needed. You are right. >> + .config = OMAP_DSS_LCD_TFT | OMAP_DSS_LCD_IVS | >> + OMAP_DSS_LCD_IHS, >> + .power_on_delay = 50, >> + .power_off_delay = 100, > > Did you check from the panel spec if any delays are needed? These look > like just copied from the Sharp panel data. Actually they were copied from some vendor code, but you are right again, I can't see anything concerning the delays in the panel spec and panel works ok with the delays thrown out. Regards, Ilya. -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
