Recent runtime pm and hwmod conversions for 2.6.39 broke the musb peripheral mode OMAP retention idle on boards where the board mode in struct musb_hdrc_platform_data is set to MUSB_PERIPHERAL. These conversions changed the way how the OTG_SYSCONFIG register is configured and used in runtime. Before 2.6.39 smart standby/idle modes were activated statically in OTG_SYSCONFIG. Those modes allow that the musb is able to idle when peripheral device is not connected to host. In 2.6.39 the OTG_SYSCONFIG is updated runtime depending on VBUS status. No standby/idle modes are used when device is connected and force standby/idle when disconnected. Unfortunately VBUS disconnect event that handles the disconnect case lets the peripheral musb to idle only when board mode is MUSB_OTG. Fix this by checking the peripheral mode also. Signed-off-by: Jarkko Nikula <jhnikula@xxxxxxxxx> --- For 2.6.39 as this fixes the PM regression on those OMAP3 boards that use musb in peripheral mode only. --- drivers/usb/musb/omap2430.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/omap2430.c index 57a27fa..e9e60b6 100644 --- a/drivers/usb/musb/omap2430.c +++ b/drivers/usb/musb/omap2430.c @@ -270,7 +270,7 @@ static int musb_otg_notifications(struct notifier_block *nb, DBG(4, "VBUS Disconnect\n"); #ifdef CONFIG_USB_GADGET_MUSB_HDRC - if (is_otg_enabled(musb)) + if (is_otg_enabled(musb) || is_peripheral_enabled(musb)) if (musb->gadget_driver) #endif { -- 1.7.4.4 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html