On Mon, 21 Mar 2011 15:50:20 +0200
Kalle Jokiniemi <kalle.jokiniemi@xxxxxxxxx> wrote:
> This patch allows the ISP1707 USB tranceiver on Nokia
> N900 to be disabled when usb cable is disconnected.
> This saves approximately 14mA of battery current.
>
I can measure that these two patches save about 14 mA.
> +static void __init rx51_xceiv_init(void)
> +{
> + if (gpio_request(RX51_USB_TRANSCEIVER_RST_GPIO, NULL) < 0)
> + BUG();
> + gpio_direction_output(RX51_USB_TRANSCEIVER_RST_GPIO, 1);
> +}
gpio_request_one makes this function needless.
> +static int rx51_xceiv_power(struct device *dev, int iD, int on)
> +{
> + unsigned long timeout;
> +
> + if (!on) {
> + /* Let musb go stdby before powering down the transceiver */
> + timeout = jiffies + msecs_to_jiffies(100);
> + while (!time_after(jiffies, timeout))
> + if (omap2_cm_read_mod_reg(CORE_MOD, CM_IDLEST1)
> + & OMAP3430ES2_ST_HSOTGUSB_STDBY_MASK)
> + break;
> + if (!(omap2_cm_read_mod_reg(CORE_MOD, CM_IDLEST1)
> + & OMAP3430ES2_ST_HSOTGUSB_STDBY_MASK))
> + WARN(1, "could not put musb to sleep\n");
> + }
> + gpio_set_value(RX51_USB_TRANSCEIVER_RST_GPIO, on);
> +
Hmm... 100 ms busy loop. I wonder are there better ways in usb to
achieve this gpio control than this loop here and playing with these
registers? I believe musb/phy/etc has knowledge when they are idle and
can do some board specific stuff?
--
Jarkko
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
