Op 25 feb 2011, om 19:57 heeft Jan, Sebastien het volgende geschreven: > On Fri, Feb 11, 2011 at 4:38 PM, Koen Kooi <koen@xxxxxxxxxxxxxxxxxxxxx> wrote: >>> I fetched this branch which contains 35 patches on top of 2.6.38-rc4. >>> After fixing some conflict, I applied these 35 patches on our Ubuntu >>> ti-omap-dev kernel. With built-in the DSS2 driver and GENERIC_DPI >>> driver, kernel boots fine on my Panda with Ubuntu GUI. But I have to >>> set the kernel boot command args with omapfb.mode=dvi:1024x768MR-24@60 >>> omapdss.def_disp=dvi, pointed out by Sebastien. Without this bootargs, >>> no graphic at all. so as Robert concerned, EDID detection doesn't >>> work. Does that related to I2C driver? I2C driver always tell me >>> timeout in dmesg. >> >> AIUI the i2c bus is only hooked up to the HDMI port, so unless you plug in something there, no dice. > > Are you sure? According to the pandaboard user manual, there seem to > be an i2c connection (i2c3): page 31, fig 9: > http://pandaboard.org/sites/default/files/board_reference/A1/Panda_Board_Spec_DOC-21010_REV0_6.pdf And so it does, it's nice to have a DDC bus on each port. I guess I got confused by the fact no kernel is using that currently :) regards, Koen-- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
