On Tue, Feb 22, 2011 at 3:19 PM, Anand Gadiyar <gadiyar@xxxxxx> wrote: > Looks like linux-next as of today is broken on at least OMAP4. > > Turning on earlyprintk, I get a crash in omap_init_mcspi. Disabling > CONFIG_SPI_OMAP24XX gets me as far as the following lines from my > bootup log, but I haven't attempted to debug further. SPI fix is available but yet be merged its discussed in this thread: http://dchs.spinics.net/lists/linux-omap/msg46446.html -- Regards, Govindraj.R > > If there are any patches out there to fix this, let me know. > Else I will debug this sometime tomorrow. > > - Anand > > > [ 0.622802] print_constraints: dummy: > [ 0.627655] NET: Registered protocol family 16 > [ 0.632537] GPMC revision 6.0 > [ 0.635681] Trying to install interrupt handler for IRQ402 > [ 0.641418] Trying to install interrupt handler for IRQ403 > [ 0.647125] Trying to install interrupt handler for IRQ404 > [ 0.652862] Trying to install interrupt handler for IRQ405 > [ 0.658599] Trying to install interrupt handler for IRQ406 > [ 0.664306] Trying to install interrupt handler for IRQ407 > [ 0.670043] Trying to install interrupt handler for IRQ408 > [ 0.675781] Trying to install type control for IRQ409 > [ 0.681060] Trying to set irq flags for IRQ409 > [ 0.685699] gpmc: irq-20 could not claim: err -22 > [ 0.695556] omap_device: omap_gpio.0: new worst case activate latency > 0: 91552 > [ 0.703552] OMAP GPIO hardware version 0.1 > [ 0.708221] OMAP GPIO hardware version 0.1 > [ 0.712890] OMAP GPIO hardware version 0.1 > [ 0.717498] OMAP GPIO hardware version 0.1 > [ 0.722137] OMAP GPIO hardware version 0.1 > [ 0.726776] OMAP GPIO hardware version 0.1[ 0.738403] omap_mux_init: > Add partition: #1: core, flags: 2 > [ 0.746276] omap_mux_init: Add partition: #2: wkup, flags: 2 > [ 0.752349] error setting wl12xx data > [ 0.759674] omap_device: omap_uart.0: new worst case deactivate latency > 0: 30517 > [ 0.769805] Failed omap4_twl6030_hsmmc_set_late_init > [ 0.777587] hw-breakpoint: found 6 breakpoint and 1 watchpoint > registers. > [ 0.784667] hw-breakpoint: 1 breakpoint(s) reserved for watchpoint > single-step. > [ 0.792266] hw-breakpoint: maximum watchpoint size is 4 bytes. > [ 0.803466] pm_dbg_init: only OMAP3 supported > [ 0.808441] OMAP DMA hardware revision 0.0 > [ 0.849426] bio: create slab <bio-0> at 0 > [ 0.856201] print_constraints: vwl1271: 1800 mV > [ 0.864959] SCSI subsystem initialized > [ 0.870605] usbcore: registered new interface driver usbfs > [ 0.876739] usbcore: registered new interface driver hub > [ 0.882751] usbcore: registered new device driver usb > [ 0.889221] omap_device: omap_i2c.1: new worst case activate latency 0: > 30517 > -- > To unsubscribe from this list: send the line "unsubscribe linux-omap" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html > -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html