Looks like linux-next as of today is broken on at least OMAP4. Turning on earlyprintk, I get a crash in omap_init_mcspi. Disabling CONFIG_SPI_OMAP24XX gets me as far as the following lines from my bootup log, but I haven't attempted to debug further. If there are any patches out there to fix this, let me know. Else I will debug this sometime tomorrow. - Anand [ 0.622802] print_constraints: dummy: [ 0.627655] NET: Registered protocol family 16 [ 0.632537] GPMC revision 6.0 [ 0.635681] Trying to install interrupt handler for IRQ402 [ 0.641418] Trying to install interrupt handler for IRQ403 [ 0.647125] Trying to install interrupt handler for IRQ404 [ 0.652862] Trying to install interrupt handler for IRQ405 [ 0.658599] Trying to install interrupt handler for IRQ406 [ 0.664306] Trying to install interrupt handler for IRQ407 [ 0.670043] Trying to install interrupt handler for IRQ408 [ 0.675781] Trying to install type control for IRQ409 [ 0.681060] Trying to set irq flags for IRQ409 [ 0.685699] gpmc: irq-20 could not claim: err -22 [ 0.695556] omap_device: omap_gpio.0: new worst case activate latency 0: 91552 [ 0.703552] OMAP GPIO hardware version 0.1 [ 0.708221] OMAP GPIO hardware version 0.1 [ 0.712890] OMAP GPIO hardware version 0.1 [ 0.717498] OMAP GPIO hardware version 0.1 [ 0.722137] OMAP GPIO hardware version 0.1 [ 0.726776] OMAP GPIO hardware version 0.1[ 0.738403] omap_mux_init: Add partition: #1: core, flags: 2 [ 0.746276] omap_mux_init: Add partition: #2: wkup, flags: 2 [ 0.752349] error setting wl12xx data [ 0.759674] omap_device: omap_uart.0: new worst case deactivate latency 0: 30517 [ 0.769805] Failed omap4_twl6030_hsmmc_set_late_init [ 0.777587] hw-breakpoint: found 6 breakpoint and 1 watchpoint registers. [ 0.784667] hw-breakpoint: 1 breakpoint(s) reserved for watchpoint single-step. [ 0.792266] hw-breakpoint: maximum watchpoint size is 4 bytes. [ 0.803466] pm_dbg_init: only OMAP3 supported [ 0.808441] OMAP DMA hardware revision 0.0 [ 0.849426] bio: create slab <bio-0> at 0 [ 0.856201] print_constraints: vwl1271: 1800 mV [ 0.864959] SCSI subsystem initialized [ 0.870605] usbcore: registered new interface driver usbfs [ 0.876739] usbcore: registered new interface driver hub [ 0.882751] usbcore: registered new device driver usb [ 0.889221] omap_device: omap_i2c.1: new worst case activate latency 0: 30517 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
