On Fri, 2011-02-18 at 15:07 +0200, Tomi Valkeinen wrote: > On Fri, 2011-02-18 at 06:55 -0600, Daniel Morsing wrote: > > On Fri, 2011-02-18 at 13:36 +0100, Thomas Weber wrote: > > > Hello Daniel, > > > > > > Am 12.02.2011 18:02, schrieb Daniel Morsing: > > > > This patch adds a generic panel entry for the 4.3 inch display that is > > > > sold with the devkit8000 and modifies the board file to use this > > > > display. > > > > > > > > > > > > > > So only the 4.3 inch display can be used with the devkit8000? > > > There are also Devkit8000 with 5.6 and 7 inch displays. > > > > > > Regards, > > > Thomas > > > > > > > Yeah, I'll admit that the patch is a bit one-sided. I couldn't find a > > way to specify a board using a class of displays with separate timing > > settings. > > > > One way to do it would be to add the settings to modedb, but modedb is > > really only for standardized display settings. The other way to do it > > would be to add a kernel config for which display you have connected to > > the board, but I think that is a bad idea, because it makes everything > > more complicated and switching out displays would require recompiling > > the kernel. > > > > Maybe Tomi or the fbdev guys have some input on how to best do this? > > There's no proper way for this currently. And I'm not even sure what > would be a good way to do this. > > Optimally the board code could read some configuration value from eeprom > or where-ever, which would tell the configuration of the board. And the > board file could then configure the correct display. > > Another way would be to add a devkit8000 specific kernel parameter, > given from bootloader, which would tell the configuration. The board > file would use this parameter to configure the correct display. > > Tomi > > How about making it possible to give a generic panel name to the omapfb.mode boot parameter? This would also solve the problem for any future boards with different non-standard displays. Regards, Daniel Morsing -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
