Please see responses inline below.
Hi Nagendra,
> Hi All,
>
> We are working on Power management on OMAP3 (3530) and I am trying to
> disable CLKEN and HFCLKOUT through TWL4030 power scripts. However we have
> not been able to achieve this.
>
> Following are the changes and tests done so far.
>
> - VAUX1, CLKEN and HFCLKOUT were assigned to P1 group.
> - Wrote Singular messages to turn on/off these signals in TWL4030 scripts.
> - We observed that VAUX1 is able to switch ON/OFF properly as per the
script
> but HFCLKOUT and CLKEN are not behaving as expected.
> - However if we try writing CLKEN_DEV_GRP to zero, CLKEN is going low.
> - We have made sure that SYS_OFF_MODE and CLK_REQ signals go low during
the
> system OFF mode, LVL_WAKEUP bit enabled in Px_SW_EVENTS, and STS_CHG bit
in
> STS_HW_CONDITIONS is zero.
>
> Is there anything that I am missing? Kindly let me know.
Did try probing the sys_clkreq from OMAP?
<Nagendra> Yes nSLEEP1, nSLEEP2 and SYS_CLK_REQ signals go low during system
OFF mode.
Are you sending SLEEP/OFF command in singular msg?
<Nagendra> Yes.
Also check the HFCLKOUT_REMAP register for SLEEP_STATE[3:0], if using SLEEP
cmd.
<Nagendra>
We are setting SLEEP_STATE field of CLKEN and HFCLKOUT to OFF mode.
PSP version : 3.0.1.6
Following is the TWL4030 power scripts that we are trying to get CLKEN
signal to OFF state. This is based on rx51-peripherals.c
-----------------------------------------------
static struct twl4030_ins sleep_on_seq[] __initdata = {
{MSG_SINGULAR(DEV_GRP_P1, RES_CLKEN, RES_STATE_OFF), 2},
};
static struct twl4030_script sleep_on_script __initdata = {
.script = sleep_on_seq,
.size = ARRAY_SIZE(sleep_on_seq),
.flags = TWL4030_SLEEP_SCRIPT,
};
static struct twl4030_ins wakeup_seq[] __initdata = {
{MSG_SINGULAR(DEV_GRP_P1, RES_CLKEN, RES_STATE_ACTIVE), 2},
};
static struct twl4030_script wakeup_script __initdata = {
.script = wakeup_seq,
.size = ARRAY_SIZE(wakeup_seq),
.flags = TWL4030_WAKEUP12_SCRIPT,
};
static struct twl4030_ins wakeup_p3_seq[] __initdata = {
{MSG_SINGULAR(DEV_GRP_P3, RES_CLKEN, RES_STATE_ACTIVE), 2},
};
static struct twl4030_script wakeup_p3_script __initdata = {
.script = wakeup_p3_seq,
.size = ARRAY_SIZE(wakeup_p3_seq),
.flags = TWL4030_WAKEUP3_SCRIPT,
};
static struct twl4030_ins wrst_seq[] __initdata = {
/*
* Reset twl4030.
* Reset VDD1 regulator.
* Reset VDD2 regulator.
* Reset VPLL1 regulator.
* Enable sysclk output.
* Reenable twl4030.
*/
{MSG_SINGULAR(DEV_GRP_NULL, RES_RESET, RES_STATE_OFF), 2},
{MSG_BROADCAST(DEV_GRP_NULL, RES_GRP_ALL, 0, 1, RES_STATE_ACTIVE),
0x13},
{MSG_BROADCAST(DEV_GRP_NULL, RES_GRP_PP, 0, 3, RES_STATE_OFF),
0x13},
{MSG_SINGULAR(DEV_GRP_NULL, RES_VDD1, RES_STATE_WRST), 0x13},
{MSG_SINGULAR(DEV_GRP_NULL, RES_VDD2, RES_STATE_WRST), 0x13},
{MSG_SINGULAR(DEV_GRP_NULL, RES_VPLL1, RES_STATE_WRST), 0x35},
{MSG_SINGULAR(DEV_GRP_P3, RES_HFCLKOUT, RES_STATE_ACTIVE), 2},
{MSG_SINGULAR(DEV_GRP_NULL, RES_RESET, RES_STATE_ACTIVE), 2},
};
static struct twl4030_script wrst_script __initdata = {
.script = wrst_seq,
.size = ARRAY_SIZE(wrst_seq),
.flags = TWL4030_WRST_SCRIPT,
};
static struct twl4030_script *twl4030_scripts[] __initdata = {
/* wakeup12 script should be loaded before sleep script, otherwise a
board might hit retention before loading of wakeup script is
completed. This can cause boot failures depending on timing
issues.
*/
&wakeup_script,
&sleep_on_script,
&wakeup_p3_script,
&wrst_script,
};
static struct twl4030_resconfig twl4030_rconfig[] __initdata = {
{ .resource = RES_CLKEN, .devgroup = DEV_GRP_P1,
.type = -1, .type2 = -1 , .remap_off = RES_STATE_OFF, .remap_sleep
= RES_STATE_OFF
},
{ .resource = RES_HFCLKOUT, .devgroup = -1,
.type = -1, .type2 = -1, .remap_off = RES_STATE_OFF, .remap_sleep
= RES_STATE_OFF
},
{ 0, 0},
};
----------------------------------------------------------
Please let me know your comments.
Regards,
Lesly A M
>
> Part number of TPS used in our board is TPS65950 BZXNR
>
> with regards,
> - Nagendra.
>
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
