The OMAP3 IGEP module has one EHCI interface on board using
USB2HS port. GPIO183 is used as PHY reset.
Signed-off-by: Enric Balletbo i Serra <eballetbo@xxxxxxxxx>
---
arch/arm/mach-omap2/board-igep0030.c | 15 ++++++++++++++-
1 files changed, 14 insertions(+), 1 deletions(-)
diff --git a/arch/arm/mach-omap2/board-igep0030.c b/arch/arm/mach-omap2/board-igep0030.c
index c88e8f7..f0a85c1 100644
--- a/arch/arm/mach-omap2/board-igep0030.c
+++ b/arch/arm/mach-omap2/board-igep0030.c
@@ -43,7 +43,7 @@
#define IGEP3_GPIO_WIFI_NRESET 139
#define IGEP3_GPIO_BT_NRESET 137
-#define IGEP3_GPIO_USBH_NRESET 115
+#define IGEP3_GPIO_USBH_NRESET 183
#if defined(CONFIG_MTD_ONENAND_OMAP2) || \
@@ -363,8 +363,20 @@ static void __init igep3_wifi_bt_init(void)
void __init igep3_wifi_bt_init(void) {}
#endif
+static const struct ehci_hcd_omap_platform_data ehci_pdata __initconst = {
+ .port_mode[0] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+ .port_mode[1] = EHCI_HCD_OMAP_MODE_PHY,
+ .port_mode[2] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+
+ .phy_reset = true,
+ .reset_gpio_port[0] = -EINVAL,
+ .reset_gpio_port[1] = IGEP3_GPIO_USBH_NRESET,
+ .reset_gpio_port[2] = -EINVAL,
+};
+
#ifdef CONFIG_OMAP_MUX
static struct omap_board_mux board_mux[] __initdata = {
+ OMAP3_MUX(I2C2_SDA, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT),
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
#endif
@@ -378,6 +390,7 @@ static void __init igep3_init(void)
omap_serial_init();
usb_musb_init(&musb_board_data);
+ usb_ehci_init(&ehci_pdata);
igep3_flash_init();
igep3_leds_init();
--
1.7.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
