Hi, On Mon, Jan 10, 2011 at 06:47:58AM -0500, Brad Parker wrote: > I know this is a top post, and a comment on a post from August, but I'd like > to point out that without this patch I can't get musb host mode to work > on the beagle board xm (3630). > > With this patch, host mode works. If I disconnect and reconnect the port > goes into "a_idle", which is almost right, and will go into host mode if > I "echo >/sys/devices/platform/musb_hdrc/mode". > > (my expectation is that the mode should toggle from "b_idle" to "a_host" > when I plug in an a connector with the id pin tied correctly, and > back to "b_idle" > when I disconnect) > > It seems like few people people test host mode on the omap twl otg port, > but I have applications which use it... > > should this patch get more attention? (there was no response to the > initial post I could find) What's the problem in simply insmoding a gadget driver ? If you have OTG enabled, you _need_ a gadget driver to have a fully working setup. If you want host only, then change Kconfig. -- balbi -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html