On Thu, 23 Dec 2010 17:37:12 -0700, Grant Likely <grant.likely@xxxxxxxxxxxx> wrote: > On Thu, Dec 23, 2010 at 4:09 PM, Ben Gamari <bgamari.foss@xxxxxxxxx> wrote: > > The reason I left this up to the board is it's easy to foresee cases > > where you want a non-trivial mapping between logical CS numbers and CS > > pin states. In my case, I using a 2-to-4 multiplexer as the source of > > chip select. > > Hi Ben, > > I understand and appreciate the motivation. However in practice, the > gpio api is sufficient for pretty much any use case, even when the > backing gpio controller driver ends up driving some oddball device > with different constraints. The big downside to using a callback is > that it forces all users to do the extra work of implementing the > callback. With the gpio api, only the oddball cases have to do extra > code (to adapt the custom device to the gpio api). I understand your concerns, but I'm not sure how to satisfy them without crippling the design's ability to accomodate my use-case. I can't pass a GPIO line per spi_board_info since in my case of a multiplexed CS configuration a single pin's state does not uniquely determine the desired CS. The only other option I can think of is that we somehow provide a list of GPIOs for each bus and map the CS numbers to permutations of GPIO states. Unfortunately, I don't know of any suitable structure to put this GPIO list in. Perhaps I'm missing something obvious? - Ben -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html