* Kevin Hilman <khilman@xxxxxxxxxxxxxxxxxxx> [101213 19:17]: > Tony Lindgren <tony@xxxxxxxxxxx> writes: > > > Use omap_serial_init_port so we can let the serial code handle the > > remuxing of the RX pads. > > > > Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx> > > Does this work for UART wakeups on n810? I don't see any 'idle' value > for the pads, so I'm guessing it wont work without those, right? Or am > I missing something here. Well this is still missing the gpio_request parts that are needed for the serial port to wake. I have not added that as it currently means we also get a gpio interrupt for every rx. I'll do more patches to deal with the gpio parts later on. The idle values are only needed for rx pins: +static struct omap_device_pad serial2_pads[] __initdata = { + { + .name = "uart3_rx_irrx.uart3_rx_irrx", + .flags = OMAP_DEVICE_PAD_REMUX | OMAP_DEVICE_PAD_WAKEUP, + .enable = OMAP_MUX_MODE0, + .idle = OMAP_MUX_MODE3 /* Mux as GPIO for idle */ + }, + { .name = "uart3_tx_irtx.uart3_tx_irtx", .enable = OMAP_MUX_MODE0, }, +}; For the others, nothing is done dynamically. Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html