With TWL6030-usb, VBUS SESS_VLD and SESS_END events are not generated
as expected. When these interrupts are enabled, charger VBUS detection
interrupt does not get generated. So USBOTG has to be dependent on charger
VBUS interrupts.
So added one bit for USBOTG and changed the handler to call the
USBOTG handler whenever there is a charger VBUS interrpt.
VBUS SESS_VLD and SESS_END event generation issue is under debug with
HW team. This fix might not be required once after fixing the issue.
Signed-off-by: Balaji TK <balajitk@xxxxxx>
Signed-off-by: Hema HK <hemahk@xxxxxx>
Cc: Felipe Balbi <balbi@xxxxxx>
Cc: Samuel Ortiz <sameo@xxxxxxxxxxxxxxx>
---
drivers/mfd/twl6030-irq.c | 9 ++++++++-
1 file changed, 8 insertions(+), 1 deletion(-)
Index: usb/drivers/mfd/twl6030-irq.c
===================================================================
--- usb.orig/drivers/mfd/twl6030-irq.c
+++ usb/drivers/mfd/twl6030-irq.c
@@ -74,7 +74,7 @@ static int twl6030_interrupt_mapping[24]
USBOTG_INTR_OFFSET, /* Bit 16 ID_WKUP */
USBOTG_INTR_OFFSET, /* Bit 17 VBUS_WKUP */
USBOTG_INTR_OFFSET, /* Bit 18 ID */
- USBOTG_INTR_OFFSET, /* Bit 19 VBUS */
+ USB_PRES_INTR_OFFSET, /* Bit 19 VBUS */
CHARGER_INTR_OFFSET, /* Bit 20 CHRG_CTRL */
CHARGER_INTR_OFFSET, /* Bit 21 EXT_CHRG */
CHARGER_INTR_OFFSET, /* Bit 22 INT_CHRG */
@@ -128,6 +128,13 @@ static int twl6030_irq_thread(void *data
sts.bytes[3] = 0; /* Only 24 bits are valid*/
+ /*
+ * Since VBUS status bit is not reliable for VBUS disconnect
+ * use CHARGER VBUS detection status bit instead.
+ */
+ if (sts.bytes[2] & 0x10)
+ sts.bytes[2] |= 0x08;
+
for (i = 0; sts.int_sts; sts.int_sts >>= 1, i++) {
local_irq_disable();
if (sts.int_sts & 0x1) {
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
