Re: [PATCH v4 1/4] omap4 hsmmc: Adding card detect support for MMC1

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Samuel,

Could you please review this patch which touches mfd/twl6030-irq.c for
card detect support
of MMC1 controller on OMAP4.

Regards,
Kishore

On Mon, Sep 27, 2010 at 1:25 PM, kishore kadiyala
<kishorek.kadiyala@xxxxxxxxx> wrote:
> Cc: Samuel Ortiz <sameo@xxxxxxxxxxxxxxx>
>
> On Fri, Sep 24, 2010 at 10:43 PM, kishore kadiyala
> <kishore.kadiyala@xxxxxx> wrote:
>> Adding card detect callback function and card detect configuration
>> function for MMC1 Controller on OMAP4.
>>
>> Card detect configuration function does initial configuration of the
>> MMC Control & PullUp-PullDown registers of Phoenix.
>>
>> For MMC1 Controller, card detect interrupt source is
>> twl6030 which is non-gpio. The card detect call back function provides
>> card present/absent status by reading MMC Control register present
>> on twl6030.
>>
>> Since OMAP4 doesn't use any GPIO line as used in OMAP3 for card detect,
>> the suspend/resume initialization which was done in omap_hsmmc_gpio_init
>> previously is moved to the probe thus making it generic for both OMAP3 & OMAP4.
>>
>> Cc: Tony Lindgren <tony@xxxxxxxxxxx>
>> Cc: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx>
>> Cc: Madhusudhan Chikkature <madhu.cr@xxxxxx>
>> Cc: Adrian Hunter <adrian.hunter@xxxxxxxxx>
>> Signed-off-by: Kishore Kadiyala <kishore.kadiyala@xxxxxx>
>> ---
>>  arch/arm/mach-omap2/board-4430sdp.c |    7 +++-
>>  drivers/mfd/twl6030-irq.c           |   73 +++++++++++++++++++++++++++++++++++
>>  drivers/mmc/host/omap_hsmmc.c       |    4 +-
>>  include/linux/i2c/twl.h             |   31 +++++++++++++++
>>  4 files changed, 112 insertions(+), 3 deletions(-)
>>
>> diff --git a/arch/arm/mach-omap2/board-4430sdp.c b/arch/arm/mach-omap2/board-4430sdp.c
>> index 9447644..a49f285 100644
>> --- a/arch/arm/mach-omap2/board-4430sdp.c
>> +++ b/arch/arm/mach-omap2/board-4430sdp.c
>> @@ -227,9 +227,14 @@ static int omap4_twl6030_hsmmc_late_init(struct device *dev)
>>        struct omap_mmc_platform_data *pdata = dev->platform_data;
>>
>>        /* Setting MMC1 Card detect Irq */
>> -       if (pdev->id == 0)
>> +       if (pdev->id == 0) {
>> +               ret = twl6030_mmc_card_detect_config();
>> +               if (ret)
>> +                       pr_err("Failed configuring MMC1 card detect\n");
>>                pdata->slots[0].card_detect_irq = TWL6030_IRQ_BASE +
>>                                                MMCDETECT_INTR_OFFSET;
>> +               pdata->slots[0].card_detect = twl6030_mmc_card_detect;
>> +       }
>>        return ret;
>>  }
>>
>> diff --git a/drivers/mfd/twl6030-irq.c b/drivers/mfd/twl6030-irq.c
>> index 10bf228..2d3bb82 100644
>> --- a/drivers/mfd/twl6030-irq.c
>> +++ b/drivers/mfd/twl6030-irq.c
>> @@ -36,6 +36,7 @@
>>  #include <linux/irq.h>
>>  #include <linux/kthread.h>
>>  #include <linux/i2c/twl.h>
>> +#include <linux/platform_device.h>
>>
>>  /*
>>  * TWL6030 (unlike its predecessors, which had two level interrupt handling)
>> @@ -223,6 +224,78 @@ int twl6030_interrupt_mask(u8 bit_mask, u8 offset)
>>  }
>>  EXPORT_SYMBOL(twl6030_interrupt_mask);
>>
>> +int twl6030_mmc_card_detect_config(void)
>> +{
>> +       int ret;
>> +       u8 reg_val = 0;
>> +
>> +       /* Unmasking the Card detect Interrupt line for MMC1 from Phoenix */
>> +       twl6030_interrupt_unmask(TWL6030_MMCDETECT_INT_MASK,
>> +                                               REG_INT_MSK_LINE_B);
>> +       twl6030_interrupt_unmask(TWL6030_MMCDETECT_INT_MASK,
>> +                                               REG_INT_MSK_STS_B);
>> +       /*
>> +        * Intially Configuring MMC_CTRL for receving interrupts &
>> +        * Card status on TWL6030 for MMC1
>> +        */
>> +       ret = twl_i2c_read_u8(TWL6030_MODULE_ID0, &reg_val, TWL6030_MMCCTRL);
>> +       if (ret < 0) {
>> +               pr_err("twl6030: Failed to read MMCCTRL, error %d\n", ret);
>> +               return ret;
>> +       }
>> +       reg_val &= ~VMMC_AUTO_OFF;
>> +       reg_val |= SW_FC;
>> +       ret = twl_i2c_write_u8(TWL6030_MODULE_ID0, reg_val, TWL6030_MMCCTRL);
>> +       if (ret < 0) {
>> +               pr_err("twl6030: Failed to write MMCCTRL, error %d\n", ret);
>> +               return ret;
>> +       }
>> +
>> +       /* Configuring PullUp-PullDown register */
>> +       ret = twl_i2c_read_u8(TWL6030_MODULE_ID0, &reg_val,
>> +                                               TWL6030_CFG_INPUT_PUPD3);
>> +       if (ret < 0) {
>> +               pr_err("twl6030: Failed to read CFG_INPUT_PUPD3, error %d\n",
>> +                                                                       ret);
>> +               return ret;
>> +       }
>> +       reg_val &= ~(MMC_PU | MMC_PD);
>> +       ret = twl_i2c_write_u8(TWL6030_MODULE_ID0, reg_val,
>> +                                               TWL6030_CFG_INPUT_PUPD3);
>> +       if (ret < 0) {
>> +               pr_err("twl6030: Failed to write CFG_INPUT_PUPD3, error %d\n",
>> +                                                                       ret);
>> +               return ret;
>> +       }
>> +       return 0;
>> +}
>> +EXPORT_SYMBOL(twl6030_mmc_card_detect_config);
>> +
>> +int twl6030_mmc_card_detect(struct device *dev, int slot)
>> +{
>> +       int ret = -EIO;
>> +       u8 read_reg = 0;
>> +       struct platform_device *pdev = to_platform_device(dev);
>> +
>> +       if (pdev->id) {
>> +               /* TWL6030 provide's Card detect support for
>> +                * only MMC1 controller.
>> +                */
>> +               pr_err("Unkown MMC controller %d in %s\n", pdev->id, __func__);
>> +               return ret;
>> +       }
>> +       /*
>> +        * BIT0 of MMC_CTRL on TWL6030 provides card status for MMC1
>> +        * 0 - Card not present ,1 - Card present
>> +        */
>> +       ret = twl_i2c_read_u8(TWL6030_MODULE_ID0, &read_reg,
>> +                                               TWL6030_MMCCTRL);
>> +       if (ret >= 0)
>> +               ret = read_reg & STS_MMC;
>> +       return ret;
>> +}
>> +EXPORT_SYMBOL(twl6030_mmc_card_detect);
>> +
>>  int twl6030_init_irq(int irq_num, unsigned irq_base, unsigned irq_end)
>>  {
>>
>> diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
>> index 562dbbb..a51894d 100644
>> --- a/drivers/mmc/host/omap_hsmmc.c
>> +++ b/drivers/mmc/host/omap_hsmmc.c
>> @@ -466,8 +466,6 @@ static int omap_hsmmc_gpio_init(struct omap_mmc_platform_data *pdata)
>>        int ret;
>>
>>        if (gpio_is_valid(pdata->slots[0].switch_pin)) {
>> -               pdata->suspend = omap_hsmmc_suspend_cdirq;
>> -               pdata->resume = omap_hsmmc_resume_cdirq;
>>                if (pdata->slots[0].cover)
>>                        pdata->slots[0].get_cover_state =
>>                                        omap_hsmmc_get_cover_state;
>> @@ -2211,6 +2209,8 @@ static int __init omap_hsmmc_probe(struct platform_device *pdev)
>>                                "Unable to grab MMC CD IRQ\n");
>>                        goto err_irq_cd;
>>                }
>> +               pdata->suspend = omap_hsmmc_suspend_cdirq;
>> +               pdata->resume = omap_hsmmc_resume_cdirq;
>>        }
>>
>>        omap_hsmmc_disable_irq(host);
>> diff --git a/include/linux/i2c/twl.h b/include/linux/i2c/twl.h
>> index 6de90bf..e64894c 100644
>> --- a/include/linux/i2c/twl.h
>> +++ b/include/linux/i2c/twl.h
>> @@ -141,6 +141,16 @@
>>  #define TWL6030_CHARGER_CTRL_INT_MASK  0x10
>>  #define TWL6030_CHARGER_FAULT_INT_MASK         0x60
>>
>> +#define TWL6030_MMCCTRL                0xEE
>> +#define VMMC_AUTO_OFF                  (0x1 << 3)
>> +#define SW_FC                          (0x1 << 2)
>> +#define STS_MMC                        0x1
>> +
>> +#define TWL6030_CFG_INPUT_PUPD3        0xF2
>> +#define MMC_PU                         (0x1 << 3)
>> +#define MMC_PD                         (0x1 << 2)
>> +
>> +
>>
>>  #define TWL4030_CLASS_ID               0x4030
>>  #define TWL6030_CLASS_ID               0x6030
>> @@ -173,6 +183,27 @@ int twl_i2c_read(u8 mod_no, u8 *value, u8 reg, unsigned num_bytes);
>>  int twl6030_interrupt_unmask(u8 bit_mask, u8 offset);
>>  int twl6030_interrupt_mask(u8 bit_mask, u8 offset);
>>
>> +/* Card detect Configuration for MMC1 Controller on OMAP4 */
>> +#ifdef CONFIG_TWL4030_CORE
>> +int twl6030_mmc_card_detect_config(void);
>> +#else
>> +static inline int twl6030_mmc_card_detect_config(void)
>> +{
>> +       pr_debug("twl6030_mmc_card_detect_config not supported\n");
>> +       return 0;
>> +}
>> +#endif
>> +
>> +/* MMC1 Controller on OMAP4 uses Phoenix irq for Card detect */
>> +#ifdef CONFIG_TWL4030_CORE
>> +int twl6030_mmc_card_detect(struct device *dev, int slot);
>> +#else
>> +static inline int twl6030_mmc_card_detect(struct device *dev, int slot)
>> +{
>> +       pr_debug("Call back twl6030_mmc_card_detect not supported\n");
>> +       return -EIO;
>> +}
>> +#endif
>>  /*----------------------------------------------------------------------*/
>>
>>  /*
>> --
>> 1.7.0.4
>>
>>
>> --
>> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
>> the body of a message to majordomo@xxxxxxxxxxxxxxx
>> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Arm (vger)]     [ARM Kernel]     [ARM MSM]     [Linux Tegra]     [Linux WPAN Networking]     [Linux Wireless Networking]     [Maemo Users]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Trails]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux