Enable omap-serial driver in /mach-omap2/Kconfig and move 8250 driver selection for zoom boards. With omap-serial driver addition all omap-uarts can be handled with omap-serial driver. With addition of omap-serial driver console parameter needs be changed in bootargs from ttyS* should be replaced with ttyO* [O --> OMAP not ZERO] For example: ttyS0[UART1 on 3430SDP] changes to ttyO0. But with some boards that do not use omap-uart as console uart. we need to handle them with 8250 driver. Ex: ZOOM2/3. For zoom2/3 board we need to use 8250 serial driver and console parameter will remain ttyS0 which basically uses a Quad uart placed on the debug board connected through a gpio line. Cc: Kevin Hilman <khilman@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Govindraj.R <govindraj.raja@xxxxxx> --- arch/arm/mach-omap2/Kconfig | 11 ++++++++--- 1 files changed, 8 insertions(+), 3 deletions(-) diff --git a/arch/arm/mach-omap2/Kconfig b/arch/arm/mach-omap2/Kconfig index b48bacf..19b6c5f 100644 --- a/arch/arm/mach-omap2/Kconfig +++ b/arch/arm/mach-omap2/Kconfig @@ -11,9 +11,8 @@ config ARCH_OMAP2PLUS_TYPICAL select PM_RUNTIME select VFP select NEON if ARCH_OMAP3 || ARCH_OMAP4 - select SERIAL_8250 - select SERIAL_CORE_CONSOLE - select SERIAL_8250_CONSOLE + select SERIAL_OMAP + select SERIAL_OMAP_CONSOLE select I2C select I2C_OMAP select MFD @@ -200,12 +199,18 @@ config MACH_OMAP_ZOOM2 depends on ARCH_OMAP3 default y select OMAP_PACKAGE_CBB + select SERIAL_8250 + select SERIAL_CORE_CONSOLE + select SERIAL_8250_CONSOLE config MACH_OMAP_ZOOM3 bool "OMAP3630 Zoom3 board" depends on ARCH_OMAP3 default y select OMAP_PACKAGE_CBP + select SERIAL_8250 + select SERIAL_CORE_CONSOLE + select SERIAL_8250_CONSOLE config MACH_CM_T35 bool "CompuLab CM-T35 module" -- 1.6.3.3 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
