Woodruff, Richard wrote:
From: linux-omap-owner@xxxxxxxxxxxxxxx [mailto:linux-omap-
owner@xxxxxxxxxxxxxxx] On Behalf Of Dirk Behme
Sent: Sunday, October 18, 2009 11:45 AM
It would be funny if the TRM was wrong and the CIRQ bit is really
cleared by writing 1 to it. I'll try that.
A while back I hunted down a few of the bits for this. Maybe this will help some.
SYSCONFIG.ENAWAKEUP = 1 < allow ocp wrapper to generate an interrupt to prcm>
MMCHS_HCTL.IWE = 1 < route wake up to module ocp wrapper>
MMCHS_CON.CPTL = 1 < Don't disable input buffer on DAT1 after completion to allow seeing SDIO interrupt>
MMCHS_HCTL.IWE
MMCHS_ISE.CIRQ_ENABLE <bit to write to enable interrupt at pin>
MMCHS_STAT<bit to write for clear of SDIO interrupt>
CCCCR - IRQ_ENABLE (think host stack will do this)
Thanks!
Do you have any idea about MMCHS_HCTL.IBG?
<This bit is valid only in 4-bit mode of SDIO card to enable interrupt
detection in the interrupt cycle at block gap for a multiple block
transfer.
For MMC cards and for SD card this bit should be set to 0.
0x0: Disable interrupt detection at the block gap in 4-bit mode
0x1: Enable interrupt detection at the block gap in 4-bit mode>
I saw it neither in the exiting code I looked at, nor in your
description above. But it sounds to me that it should be set for 4-bit
mode?
Best regards
Dirk
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
