Tony Lindgren <tony@xxxxxxxxxxx> writes:
> We currently are getting the following warning after a system suspend:
>
> Powerdomain (vpe_pwrdm) didn't enter target state 0
>
> Looks like this is because the STANDBYMODE bit for SMART_IDLE should
> not be used. The TRM "Table 12-348. VPE_SYSCONFIG" says that the value
> for SMART_IDLE is "0x2: Same behavior as bit-field value of 0x1". But
> if the SMART_IDLE value is used, PM_VPE_PWRSTST LASTPOWERSTATEENTERED
> bits always show value of 3.
>
> Let's fix the issue by dropping SMART_IDLE for vpe. And let's also add
> the missing the powerdomain for vpe.
>
> Fixes: 1a2095160594 ("ARM: dts: dra7: Add ti-sysc node for VPE")
> Cc: Benoit Parrot <bparrot@xxxxxx>
> Reported-by: Kevin Hilman <khilman@xxxxxxxxxxxx>
> Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx>
Thanks for the fix. Verified on beagle-x5.
Reviewed-by: Kevin Hilman <khilman@xxxxxxxxxxxx>
Tested-by: Kevin Hilman <khilman@xxxxxxxxxxxx>
