Guess: this bit in JTAG script used for IVA tests probably is missing and needs to be worked in. The generic linux-omap clock code probably handles the IVA clock but maybe not the resets. /* Enable IVA-ss functional clock (set bit 0) */ (*(int*)0x49006800) |= 0x1; /* Release l3s_idle_req */ (*(int*)0x49006810) |= (1 << 1); /* Release L3S reset and power-on reset (clear bit 1) at the same time */ (*(int*)0x49006850) &= ~(( 1 << 1)); Regards, Richard W. -----Original Message----- From: David Russell <david.russell73@xxxxxxxxx> Sent: Monday, June 07, 2021 10:01 AM To: tony@xxxxxxxxxxx Cc: linux-omap@xxxxxxxxxxxxxxx Subject: [EXTERNAL] OMAP2430 kernel hangs on ioremap of IVA2.1 addresses Good morning, I have a legacy project that runs on an OMAP2430 and is based on the linux-omap repo (tag v2.6.28-omap1). I am in the process of upgrading the project to mainline v5.10; I have been able to get most issues resolved (e.g., USB DMA still fails, but PIO works for now), but have a difficult problem that I am hoping someone might lend an idea to. We have a custom DSP driver that is responsible for resetting the DSP, downloading the firmware, setting up the mailbox and then managing the communication between the ARM and DSP. I have the driver mostly ported (i.e., compiling) and am working through the behavior. At probe-time there are several ioremap’s of IVA2.1 memory (0x5c800000 and 0x5d000000 — the internal SRAM and the MMU). The ioremap’s succeed without error, but as soon as I simply try to read the revision register at 0x5d000000 the ARM hangs (i.e., not even a kernel panic message is presented, the console just freezes). I assume that I am missing a clock or some module is powered-down, but am not sure. Interestingly, in arch/arm/mach-omap2/iomap.h it is explicitly noted that the 2430 IVA2.1 is not mapped — I attempted to add these mappings to the 2430 table which resulted in zero console output of the kernel boot (i.e., I can see the x-loader console output getting ready to launch the kernel, and then nothing). This is a challenging problem with the console simply freezing on the memory access. I would very much appreciate any ideas as to this issue. Regards, Dave
