On Fri, Feb 14, 2020 at 12:34:58PM -0600, Suman Anna wrote:
Hi Sasha, On 2/14/20 9:43 AM, Sasha Levin wrote:From: Suman Anna <s-anna@xxxxxx> [ Upstream commit 4601832f40501efc3c2fd264a5a69bd1ac17d520 ] The IPU1 MMU has been using common IOMMU pdata quirks defined and used by all IPU IOMMU devices on OMAP4 and beyond. Separate out the pdata for IPU1 MMU with the additional .set_pwrdm_constraint ops plugged in, so that the IPU1 power domain can be restricted to ON state during the boot and active period of the IPU1 remote processor. This eliminates the pre-conditions for the IPU1 boot issue as described in commit afe518400bdb ("iommu/omap: fix boot issue on remoteprocs with AMMU/Unicache"). NOTE: 1. RET is not a valid target power domain state on DRA7 platforms, and IPU power domain is normally programmed for OFF. The IPU1 still fails to boot though, and an unclearable l3_noc error is thrown currently on 4.14 kernel without this fix. This behavior is slightly different from previous 4.9 LTS kernel. 2. The fix is currently applied only to IPU1 on DRA7xx SoC, as the other affected processors on OMAP4/OMAP5/DRA7 are in domains that are not entering RET. IPU2 on DRA7 is in CORE power domain which is only programmed for ON power state. The fix can be easily scaled if these domains do hit RET in the future. 3. The issue was not seen on current DRA7 platforms if any of the DSP remote processors were booted and using one of the GPTimers 5, 6, 7 or 8 on previous 4.9 LTS kernel. This was due to the errata fix for i874 implemented in commit 1cbabcb9807e ("ARM: DRA7: clockdomain: Implement timer workaround for errata i874") which keeps the IPU1 power domain from entering RET when the timers are active. But the timer workaround did not make any difference on 4.14 kernel, and an l3_noc error was seen still without this fix. Signed-off-by: Suman Anna <s-anna@xxxxxx> Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>And drop this one as well, since mainline doesn't yet boot the processors, so this is not needed for stable queue.
Now dropped, thank you. -- Thanks, Sasha
