The LP8756x family has a single output 4-phase regulator configuration. Add support for the same. The control lies in the master buck which is buck0 for 4-phase configuration. Enable/disable/voltage set happen via buck0 registers. Data Sheet: https://www.ti.com/lit/ds/symlink/lp87561-q1.pdf Signed-off-by: Keerthy <j-keerthy@xxxxxx> Acked-by: Mark Brown <broonie@xxxxxxxxxx> --- patches 1/3 2/3 are already applied to linux-next. Changes in v2: * Changed if/else block to switch statement. drivers/regulator/lp87565-regulator.c | 17 ++++++++++++++++- 1 file changed, 16 insertions(+), 1 deletion(-) diff --git a/drivers/regulator/lp87565-regulator.c b/drivers/regulator/lp87565-regulator.c index 81eb4b890c0c..af00d1ffcf33 100644 --- a/drivers/regulator/lp87565-regulator.c +++ b/drivers/regulator/lp87565-regulator.c @@ -153,6 +153,12 @@ static const struct lp87565_regulator regulators[] = { LP87565_REG_BUCK2_CTRL_1, LP87565_BUCK_CTRL_1_EN, 3230, buck0_1_2_3_ranges, LP87565_REG_BUCK2_CTRL_2), + LP87565_REGULATOR("BUCK3210", LP87565_BUCK_3210, "buck3210", + lp87565_buck_ops, 256, LP87565_REG_BUCK0_VOUT, + LP87565_BUCK_VSET, LP87565_REG_BUCK0_CTRL_1, + LP87565_BUCK_CTRL_1_EN | + LP87565_BUCK_CTRL_1_FPWM_MP_0_2, 3230, + buck0_1_2_3_ranges, LP87565_REG_BUCK0_CTRL_2), }; static int lp87565_regulator_probe(struct platform_device *pdev) @@ -169,9 +175,18 @@ static int lp87565_regulator_probe(struct platform_device *pdev) config.driver_data = lp87565; config.regmap = lp87565->regmap; - if (lp87565->dev_type == LP87565_DEVICE_TYPE_LP87565_Q1) { + switch (lp87565->dev_type) { + case LP87565_DEVICE_TYPE_LP87565_Q1: min_idx = LP87565_BUCK_10; max_idx = LP87565_BUCK_23; + break; + case LP87565_DEVICE_TYPE_LP87561_Q1: + min_idx = LP87565_BUCK_3210; + max_idx = LP87565_BUCK_3210; + default: + dev_err(lp87565->dev, "Invalid lp config %d\n", + lp87565->dev_type); + return -EINVAL; } for (i = min_idx; i <= max_idx; i++) { -- 2.17.1
