In dual_mac mode CPSW driver uses vid1 and vid2 by default to implement
dual mac mode wich are used to configure pvids for each external ports.
But, historicaly, it also adds vid0 to ALE table and sets "untag" bits for both
ext. ports. As result, it's imposible to use priority tagged packets in
dual mac mode.
Hence, drop vid0 configuration in dual mac mode as it's not required for dual
mac mode functionality and, this way, make it possible to use priority
tagged packet in dual mac mode.
Signed-off-by: Grygorii Strashko <grygorii.strashko@xxxxxx>
---
drivers/net/ethernet/ti/cpsw.c | 7 ++-----
1 file changed, 2 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c
index 15d563c..4f3a159 100644
--- a/drivers/net/ethernet/ti/cpsw.c
+++ b/drivers/net/ethernet/ti/cpsw.c
@@ -2036,9 +2036,6 @@ static int cpsw_ndo_open(struct net_device *ndev)
/* Add default VLAN */
if (!cpsw->data.dual_emac)
cpsw_add_default_vlan(priv);
- else
- cpsw_ale_add_vlan(cpsw->ale, cpsw->data.default_vlan,
- ALE_ALL_PORTS, ALE_ALL_PORTS, 0, 0);
/* initialize shared resources for every ndev */
if (!cpsw->usage_count) {
@@ -2490,7 +2487,7 @@ static int cpsw_ndo_vlan_rx_add_vid(struct net_device *ndev,
struct cpsw_common *cpsw = priv->cpsw;
int ret;
- if (vid == cpsw->data.default_vlan)
+ if (!cpsw->data.dual_emac && vid == cpsw->data.default_vlan)
return 0;
ret = pm_runtime_get_sync(cpsw->dev);
@@ -2528,7 +2525,7 @@ static int cpsw_ndo_vlan_rx_kill_vid(struct net_device *ndev,
struct cpsw_common *cpsw = priv->cpsw;
int ret;
- if (vid == cpsw->data.default_vlan)
+ if (!cpsw->data.dual_emac && vid == cpsw->data.default_vlan)
return 0;
ret = pm_runtime_get_sync(cpsw->dev);
--
2.10.5
