> Op 17 jul. 2018, om 08:16 heeft Tony Lindgren <tony@xxxxxxxxxxx> het volgende geschreven:
>
> Hi Koen,
>
> Just noticed there should be generic node names here too, see below.
>
> * Koen Kooi <koen@xxxxxxxxxxxxxxxxxxxxx> [180713 06:28]:
>> The "Beaglebone Enhanced" by Sancloud is based on the Beaglebone Black,
>> but with the following differences:
>>
>> * Gigabit capable PHY
>> * Extra USB hub, optional i2c control
>> * lps3331ap barometer connected over i2c
>> * MPU6050 6 axis MEMS accelerometer/gyro connected over i2c
>> * 1GiB DDR3 RAM
>> * RTL8723 Wifi/Bluetooth connected over USB
>
>> +&i2c0 {
>> + lps331ap: lps331ap@5C {
>> + compatible = "st,lps331ap-press";
>> + st,drdy-int-pin = <1>;
>> + reg = <0x5C>;
>> + interrupt-parent = <&gpio1>;
>> + interrupts = <26 IRQ_TYPE_EDGE_RISING>;
>> + };
>
> lps33lap: barometer@5c
>
>> + mpu6050: mpu6050@68 {
>> + compatible = "invensense,mpu6050";
>> + reg = <0x68>;
>> + interrupt-parent = <&gpio0>;
>> + interrupts = <2 IRQ_TYPE_EDGE_RISING>;
>> + orientation = <0xff 0 0 0 1 0 0 0 0xff>;
>> + };
>
> mpu6050: accelerometer@2c
>
> And so on. Please check the lower case hex numbers too as
> that’s what Linux typically uses.
Thanks for the feedback! Fixed both issues, v5 sent out.
regards,
Koen
>
> Thanks,
>
> Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
