From: Murali Karicheri <m-karicheri2@xxxxxx> The data manual for DP83867IR/CR, SNLS484E[1], revised march 2017, advises that strapping RX_DV/RX_CTRL pin in mode 1 and 2 is not supported (see note below Table 5 (4-Level Strap Pins)). There are some boards which have the pin strapped this way and need software workaround suggested by the data manual. Bit[7] of Configuration Register 4 (address 0x0031) must be cleared to 0. This ensures proper operation of the PHY. Implement driver support for device-tree property meant to advertise the wrong strapping. [1] http://www.ti.com/lit/ds/snls484e/snls484e.pdf Signed-off-by: Murali Karicheri <m-karicheri2@xxxxxx> [nsekhar@xxxxxx: rebase to mainline, code simplification] Signed-off-by: Sekhar Nori <nsekhar@xxxxxx> --- drivers/net/phy/dp83867.c | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c index b57f20e552ba..c1ab976cc800 100644 --- a/drivers/net/phy/dp83867.c +++ b/drivers/net/phy/dp83867.c @@ -91,6 +91,7 @@ struct dp83867_private { int fifo_depth; int io_impedance; int port_mirroring; + bool rxctrl_strap_quirk; }; static int dp83867_ack_interrupt(struct phy_device *phydev) @@ -164,6 +165,9 @@ static int dp83867_of_init(struct phy_device *phydev) else if (of_property_read_bool(of_node, "ti,min-output-impedance")) dp83867->io_impedance = DP83867_IO_MUX_CFG_IO_IMPEDANCE_MIN; + dp83867->rxctrl_strap_quirk = of_property_read_bool(of_node, + "ti,dp83867-rxctrl-strap-quirk"); + ret = of_property_read_u32(of_node, "ti,rx-internal-delay", &dp83867->rx_id_delay); if (ret && @@ -214,6 +218,13 @@ static int dp83867_config_init(struct phy_device *phydev) dp83867 = (struct dp83867_private *)phydev->priv; } + /* RX_DV/RX_CTRL strapped in mode 1 or mode 2 workaround */ + if (dp83867->rxctrl_strap_quirk) { + val = phy_read_mmd(phydev, DP83867_DEVADDR, DP83867_CFG4); + val &= ~BIT(7); + phy_write_mmd(phydev, DP83867_DEVADDR, DP83867_CFG4, val); + } + if (phy_interface_is_rgmii(phydev)) { val = phy_read(phydev, MII_DP83867_PHYCTRL); if (val < 0) -- 2.9.0 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
