* Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> [161110 10:18]: > I'll try to give it a go, but right now I'm stuck with a different MUSB > problem :-) I'm trying to boot my panda board over the SMSC95xx ethernet, and > have switched gadget support from being compiled in to being compiled as a > module. I then get > > [ 2.766174] musb_bus_suspend 2586: trying to suspend as a_idle while active > > printed in a loop at boot time. I've traced musb->is_active being set to 1 in > musb_start() with > > musb->port_mode = MUSB_PORT_MODE_DUAL_ROLE > musb->xceiv->otg->state = OTG_STATE_A_IDLE > devctl = MUSB_DEVCTL_BDEVICE | MUSB_DEVCTL_VBUS > > I can disable gadget support completely which will I believe fix the problem, > but that's just a workaround. Help would be appreciated. Do you have the ID pin grounded or how do you get to the A_IDLE state? I'm pretty much only testing with loadable modules as in omap2plus_defconfig, I don't think I've seen this issue.. Maybe check the changes in your .config against just plain omap2plus_defconfig? Are you trying to force host only mode? Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html