The VBUS line of USB2 is connected to VBUS detect logic on
the PMIC. Use the palmas-usb driver to report VBUS events
to the USB driver.
As the palmas-usb driver supports GPIO based ID reporting
provide the GPIO for ID pin as well.
Signed-off-by: Roger Quadros <rogerq@xxxxxx>
---
arch/arm/boot/dts/am57xx-beagle-x15.dts | 29 ++++++++++++++++-------------
1 file changed, 16 insertions(+), 13 deletions(-)
diff --git a/arch/arm/boot/dts/am57xx-beagle-x15.dts b/arch/arm/boot/dts/am57xx-beagle-x15.dts
index a63bf78..f32cf20 100644
--- a/arch/arm/boot/dts/am57xx-beagle-x15.dts
+++ b/arch/arm/boot/dts/am57xx-beagle-x15.dts
@@ -98,13 +98,6 @@
pinctrl-0 = <&extcon_usb1_pins>;
};
- extcon_usb2: extcon_usb2 {
- compatible = "linux,extcon-usb-gpio";
- id-gpio = <&gpio7 24 GPIO_ACTIVE_HIGH>;
- pinctrl-names = "default";
- pinctrl-0 = <&extcon_usb2_pins>;
- };
-
hdmi0: connector {
compatible = "hdmi-connector";
label = "hdmi";
@@ -326,12 +319,6 @@
>;
};
- extcon_usb2_pins: extcon_usb2_pins {
- pinctrl-single,pins = <
- 0x3e8 (PIN_INPUT_PULLUP | MUX_MODE14) /* uart1_ctsn.gpio7_24 */
- >;
- };
-
tpd12s015_pins: pinmux_tpd12s015_pins {
pinctrl-single,pins = <
0x3b0 (PIN_OUTPUT | MUX_MODE14) /* gpio7_10 CT_CP_HPD */
@@ -495,6 +482,14 @@
gpio-controller;
#gpio-cells = <2>;
};
+
+ extcon_usb2: tps659038_usb {
+ compatible = "ti,palmas-usb-vid";
+ ti,enable-vbus-detection;
+ ti,enable-id-detection;
+ id-gpios = <&gpio7 24 GPIO_ACTIVE_HIGH>;
+ };
+
};
tmp102: tmp102@48 {
@@ -624,6 +619,14 @@
};
&usb2 {
+ /*
+ * Stand alone usage is peripheral only.
+ * However, with some resistor modifications
+ * this port can be used via expansion connectors
+ * as "host" or "dual-role". If so, provide
+ * the necessary dr_mode override in the expansion
+ * board's DT.
+ */
dr_mode = "peripheral";
};
--
2.1.4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
