On Fri, Jan 16, 2015 at 11:50 PM, Tony Lindgren <tony@xxxxxxxxxxx> wrote: > Similar to omap_gpio_irq_type() let's make sure that the GPIO > is usable as an interrupt if the platform init code did not > call gpio_request(). Otherwise we can get invalid device access > after setup_irq(): > > WARNING: CPU: 0 PID: 1 at drivers/bus/omap_l3_noc.c:147 l3_interrupt_handler+0x214/0x340() > 44000000.ocp:L3 Custom Error: MASTER MPU TARGET L4CFG (Idle): Data Access in Supervisor mode during Functional access > ... > [<c05f21e4>] (__irq_svc) from [<c05f1974>] (_raw_spin_unlock_irqrestore+0x34/0x44) > [<c05f1974>] (_raw_spin_unlock_irqrestore) from [<c00914a8>] (__setup_irq+0x244/0x530) > [<c00914a8>] (__setup_irq) from [<c00917d4>] (setup_irq+0x40/0x8c) > [<c00917d4>] (setup_irq) from [<c0039c8c>] (omap_system_dma_probe+0x1d4/0x2b4) > [<c0039c8c>] (omap_system_dma_probe) from [<c03b2200>] (platform_drv_probe+0x44/0xa4) > ... > > We can fix this the same way omap_gpio_irq_type() is handling it. > > Note that the long term solution is to change the gpio-omap driver > to handle the banks as separate driver instances. This will allow > us to rely on just runtime PM for tracking the bank specific state. > > Reported-by: Russell King <rmk+kernel@xxxxxxxxxxxxxxxx> > Cc: Felipe Balbi <balbi@xxxxxx> > Cc: Javier Martinez Canillas <javier@xxxxxxxxxxxx> > Cc: Kevin Hilman <khilman@xxxxxxxxxx> > Cc: Linus Walleij <linus.walleij@xxxxxxxxxx> > Cc: Russell King - ARM Linux <linux@xxxxxxxxxxxxxxxx> > Cc: Santosh Shilimkar <ssantosh@xxxxxxxxxx> > Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx> Patch applied for fixes with Felipe's Tested-by. Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
