Similar to omap_gpio_irq_type() let's make sure that the GPIO
is usable as an interrupt if the platform init code did not
call gpio_request(). Otherwise we can get invalid device access
after setup_irq():
WARNING: CPU: 0 PID: 1 at drivers/bus/omap_l3_noc.c:147 l3_interrupt_handler+0x214/0x340()
44000000.ocp:L3 Custom Error: MASTER MPU TARGET L4CFG (Idle): Data Access in Supervisor mode during Functional access
...
[<c05f21e4>] (__irq_svc) from [<c05f1974>] (_raw_spin_unlock_irqrestore+0x34/0x44)
[<c05f1974>] (_raw_spin_unlock_irqrestore) from [<c00914a8>] (__setup_irq+0x244/0x530)
[<c00914a8>] (__setup_irq) from [<c00917d4>] (setup_irq+0x40/0x8c)
[<c00917d4>] (setup_irq) from [<c0039c8c>] (omap_system_dma_probe+0x1d4/0x2b4)
[<c0039c8c>] (omap_system_dma_probe) from [<c03b2200>] (platform_drv_probe+0x44/0xa4)
...
We can fix this the same way omap_gpio_irq_type() is handling it.
Note that the long term solution is to change the gpio-omap driver
to handle the banks as separate driver instances. This will allow
us to rely on just runtime PM for tracking the bank specific state.
Reported-by: Russell King <rmk+kernel@xxxxxxxxxxxxxxxx>
Cc: Felipe Balbi <balbi@xxxxxx>
Cc: Javier Martinez Canillas <javier@xxxxxxxxxxxx>
Cc: Kevin Hilman <khilman@xxxxxxxxxx>
Cc: Linus Walleij <linus.walleij@xxxxxxxxxx>
Cc: Russell King - ARM Linux <linux@xxxxxxxxxxxxxxxx>
Cc: Santosh Shilimkar <ssantosh@xxxxxxxxxx>
Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx>
---
drivers/gpio/gpio-omap.c | 39 +++++++++++++++++++++++++++++++++------
1 file changed, 33 insertions(+), 6 deletions(-)
diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index 30646cf..f476ae2 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -88,6 +88,8 @@ struct gpio_bank {
#define BANK_USED(bank) (bank->mod_usage || bank->irq_usage)
#define LINE_USED(line, offset) (line & (BIT(offset)))
+static void omap_gpio_unmask_irq(struct irq_data *d);
+
static int omap_irq_to_gpio(struct gpio_bank *bank, unsigned int gpio_irq)
{
return bank->chip.base + gpio_irq;
@@ -477,6 +479,16 @@ static int omap_gpio_is_input(struct gpio_bank *bank, int mask)
return readl_relaxed(reg) & mask;
}
+static void omap_gpio_init_irq(struct gpio_bank *bank, unsigned gpio,
+ unsigned offset)
+{
+ if (!LINE_USED(bank->mod_usage, offset)) {
+ omap_enable_gpio_module(bank, offset);
+ omap_set_gpio_direction(bank, offset, 1);
+ }
+ bank->irq_usage |= BIT(GPIO_INDEX(bank, gpio));
+}
+
static int omap_gpio_irq_type(struct irq_data *d, unsigned type)
{
struct gpio_bank *bank = omap_irq_data_get_bank(d);
@@ -506,15 +518,11 @@ static int omap_gpio_irq_type(struct irq_data *d, unsigned type)
spin_lock_irqsave(&bank->lock, flags);
offset = GPIO_INDEX(bank, gpio);
retval = omap_set_gpio_triggering(bank, offset, type);
- if (!LINE_USED(bank->mod_usage, offset)) {
- omap_enable_gpio_module(bank, offset);
- omap_set_gpio_direction(bank, offset, 1);
- } else if (!omap_gpio_is_input(bank, BIT(offset))) {
+ omap_gpio_init_irq(bank, gpio, offset);
+ if (!omap_gpio_is_input(bank, BIT(offset))) {
spin_unlock_irqrestore(&bank->lock, flags);
return -EINVAL;
}
-
- bank->irq_usage |= BIT(GPIO_INDEX(bank, gpio));
spin_unlock_irqrestore(&bank->lock, flags);
if (type & (IRQ_TYPE_LEVEL_LOW | IRQ_TYPE_LEVEL_HIGH))
@@ -792,6 +800,24 @@ exit:
pm_runtime_put(bank->dev);
}
+static unsigned int omap_gpio_irq_startup(struct irq_data *d)
+{
+ struct gpio_bank *bank = omap_irq_data_get_bank(d);
+ unsigned int gpio = omap_irq_to_gpio(bank, d->hwirq);
+ unsigned long flags;
+ unsigned offset = GPIO_INDEX(bank, gpio);
+
+ if (!BANK_USED(bank))
+ pm_runtime_get_sync(bank->dev);
+
+ spin_lock_irqsave(&bank->lock, flags);
+ omap_gpio_init_irq(bank, gpio, offset);
+ spin_unlock_irqrestore(&bank->lock, flags);
+ omap_gpio_unmask_irq(d);
+
+ return 0;
+}
+
static void omap_gpio_irq_shutdown(struct irq_data *d)
{
struct gpio_bank *bank = omap_irq_data_get_bank(d);
@@ -1181,6 +1207,7 @@ static int omap_gpio_probe(struct platform_device *pdev)
if (!irqc)
return -ENOMEM;
+ irqc->irq_startup = omap_gpio_irq_startup,
irqc->irq_shutdown = omap_gpio_irq_shutdown,
irqc->irq_ack = omap_gpio_ack_irq,
irqc->irq_mask = omap_gpio_mask_irq,
--
2.1.4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
