On 11/05/2014 08:49 PM, Tony Lindgren wrote: > * Roger Quadros <rogerq@xxxxxx> [141105 03:08]: >> On 11/04/2014 05:55 PM, Tony Lindgren wrote: >>> * Roger Quadros <rogerq@xxxxxx> [141104 02:50]: >>>> Hi Tony, >>>> >>>> These patches add CAN support for am33xx, am43xx and dra7 platforms. >>>> They must go in together with CAN driver RAMINIT Syscon support [1]. >>> >>> Can you make this series not depend on [1] for most part without >>> breaking existing functionality? >> >> I just checked that we haven't enabled DCAN on any of the boards >> so we don't risk breaking anything even if these 2 series don't go in >> together. > > OK > >>> Then we can do a single follow-up patch to enable things after [1] >>> has been merged. >>> >>> That would remove a dependency between driver changes and .dts changes. >> >> Apart from patches 1, 3 and 8, that add the control module nodes the rest >> pretty much depend on the driver DT binding changes. >> >> I can send them separately if needed. > > Well sounds like I can already apply the .dts changes without > affecting anything until the driver changes are merged. > > Let me know if that's the case and I'll apply these assuming > the binding is OK and not going to change. There is one change in the binding so I'll have to post a v4. cheers, -roger -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
