On 05/08/2014 08:03 PM, Tony Lindgren wrote: > * Nishanth Menon <nm@xxxxxx> [140506 17:25]: >> Subject: [PATCH] power: twl4030_charger: detect battery presence prior to >> enabling charger >> >> TWL4030's Battery Charger seems to be designed for non-hotpluggable >> batteries. >> >> If battery is not present in the system, BATSTS is always set with the >> expectation that software will take actions to move to a required safe >> state (could be power down or disable various charger paths). >> >> It does not seem possible even by manipulating the edge detection >> of the event (using BCIEDR2 register) to have a consistent hotplug >> handling. This seems to be the result of BATSTS interrupt generated >> when the thermistor of the battery pack is disconnected from the >> dedicated ADIN1 pin. Clearing the status just results in the status >> being regenerated by the monitoring ADC(MADC) and disabling the >> edges of event just makes hotplug no longer function. The only >> other option is to disable the detection of the MADC by disabling >> BCIMFEN4::BATSTSMCHGEN (battery presence detector) - but then, we can >> never again detect battery reconnection. >> >> So, detect battery presence based on precharge(which is hardware >> automatic state) or default main charger configuration at the time of >> probe and enable charger logic only if battery was present. >> >> Reported-by: Russell King <linux@xxxxxxxxxxxxxxxx> >> Signed-off-by: Nishanth Menon <nm@xxxxxx> > > Gets rid of the errors for me if CONFIG_CHARGER_TWL4030=y. > Looks like we don't have that enabled by default in > omap2plus_defconfig which explain why it's taken so long to > notice this one: > > Tested-by: Tony Lindgren <tony@xxxxxxxxxxx> > Thanks. I will post this out to the list as formal series. -- Regards, Nishanth Menon -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html