On 18 April 2014 17:10, Joachim Eastwood <manabian@xxxxxxxxx> wrote: > Add support for VAR-SOM-OM44[1] SODIMM system on module from Variscite. SoM > features a OMAP4460, 1GB RAM, Gigabit Ethernet (LAN7500) and optional WLAN/BT. > > Also add support for VAR-STK-OM44 development board from Variscite. This kit > features a VAR-SOM-OM44 and the carrier board VAR-OM44CustomBoard[2]. The > VAR-STK-OM44 is the same as VAR-DVK-OM44 but without the LCD display. > > omap4-var-stk-om44.dts replace the old and very limited omap4-var-som.dts. > > [1] http://www.variscite.com/products/system-on-module-som/cortex-a9/var-som-om44-cpu-ti-omap-4-omap4460 > [2] http://www.variscite.com/products/single-board-computers/var-om44customboard > > Signed-off-by: Joachim Eastwood <manabian@xxxxxxxxx> > --- Tomi, Do you plan to push the patch that add hpd-gpios to the "hdmi-connector" for 3.16? (nodes for my board below) https://patchwork.kernel.org/patch/4006021/ Also in the patch set I am using your DT bindings for "panel-dpi". See patch [2 of 4] for nodes. https://patchwork.kernel.org/patch/4047241/ Will this patch be upstream in 3.16? As I am about to send out a new version of this patch set it would be nice to know if I need to split out the display stuff, for later inclusion, or if it can go in as it is. regards Joachim Eastwood > + hdmi0: connector@0 { > + compatible = "hdmi-connector"; > + pinctrl-names = "default"; > + pinctrl-0 = <&hdmi_hpd_pins>; > + label = "hdmi"; > + type = "a"; > + > + hpd-gpios = <&gpio2 31 GPIO_ACTIVE_HIGH>; /* gpio_63 */ > + > + port { > + hdmi_connector_in: endpoint { > + remote-endpoint = <&hdmi_out>; > + }; > + }; > + }; > +}; -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
