Op 13 jan 2009, om 05:33 heeft Kevin Hilman het volgende geschreven:
Koen Kooi <k.kooi@xxxxxxxxxxxxxxxxxx> writes:Op 11 jan 2009, om 19:53 heeft Koen Kooi het volgende geschreven:Hi, I was trying to get cpufreq going on beagleboard (http://cgit.openembedded.net/cgit.cgi?url=openembedded/blob/&id=f56b27781d810dcca0a9946cfd2524c36b7a49c0&path=packages/linux/linux-omap-pm/beagle-cpufreq.diff ) and I ran into a few issues; * pm-prev branch: SD card doesn't initialize, and my rootfs is in SDSD *does* initialize, but 'rootwait' doesn't work, booting from a ubifs volume in nand works and udev automounts my SD card. Cpufreq isn't working, so I still need advice on that :)pm-next isn't supposed to work. ;) It is work in progress. Once it's ready it will become 'pm'. Re: SD/MMC problem I see the same problem in linux-omap HEAD where rootwait doesn't seem to work, so at least the 'rootwait' problem think is not PM branch related. Re: CPUfreq on Beagle. I haven't done any testing of CPUfreq on beagle. AFAICT, the OPP definitions are not being defined for Beagle. That would explain no availabe operating points. These are board specific settings. You could start by looking at the *_rate_table definitions in board-3430sdp.c.
Thats' where http://cgit.openembedded.net/cgit.cgi?url=openembedded/blob/&id=95234a14a387c1437e71eafe0c48d4ebf95a9bc8&path=packages/linux/linux-omap-pm/beagle-cpufreq.diff comes in :)
It doesn't seem to have any effect though, no 'cpufreq' prints in dmesg whatsoever (with pm-prev, that is).
regards, Koen
Kevin
Attachment:
PGP.sig
Description: Dit deel van het bericht is digitaal ondertekend
