On Thu, 2008.05.15, 136, Felipe Balbi wrote: > > Always, one of these two happens after I flash the compiled zImage: > > - The NOKIA splash screen is displayed for about 20 seconds and then the > > N810 > > powers off. > > - The splash screen is shown for <1 second and the device resets (loop); > > I > > have to remove the battery. > > flasher --enable-rd-mode --set-rd-flags=serial-console,no-lifeguard-reset > -f I had already done that, though not the serial-console one; I don't have any way to use it: > > I have enable R&D mode on the N810 and disabled the lifeguard-reset flag. > > I've used 'make n800_defconfig' (2.6.26-rc2-omap1 +N810) and changed only > > the > > default cmdline without success. Also I've used 'make > > nokia_2420_defconfig' > > with the maemo kernel. > > try also > flasher --set-root-device mmc I've tried this before, but can it really make any difference to whether the custom kernel boots? The root device doesn't matter until after I have successfully booted a kernel. > > Oh, and one more question that I ought to know the answer to by now: > > Is it okay to do 'make zImage', then change the config, then 'make > zImage' > > > > again without doing a 'make clean', so long as nothing in the source has > > been > > changed? That saves a lot of time. > > Yes, it's ok. ;-) Great, thanks!
Attachment:
signature.asc
Description: Digital signature
