On Sun, 2009-03-22 at 06:26 -0700, Garry Dolley wrote: > Dear linux-net, > > I'm running the stock kernel of Ubuntu Hardy: > 2.6.27-7-generic #1 SMP Tue Nov 4 19:33:06 UTC 2008 x86_64 GNU/Linux > > My eth0 is: > driver: e1000e > version: 0.3.3.3-k6 > firmware-version: 2.1-12 > bus-info: 0000:04:00.0 > > If have several VLANs configured on eth0, such as: > > eth0.105 > eth0.106 > eth0.107 > > When I run tcpdump on each, I can see the traffic for the respective VLAN. > When I tcpdump eth0, I can see the traffic for *all* the VLANs. > > So far so good. > > Except, when I look at the traffic for all the VLANs, the VLAN ID is not > present. Many hours of googling, looking at the e1000e driver code and VLAN > code, and picking other ppl's brains, has led me to believe that VLAN > hardware acceleration is stripping the tag from the frame, so I can't actually > see the VLAN ID. > > So my question is, is it possible to turn hwaccel off for this card without > hacking and recompiling the driver? Or can I get the VLAN ID using some other > method that I don't know about? ethtool -K--offload ethX [rx on|off] [tx on|off] [sg on|off] [tso on| off] [ufo on|off] [gso on|off] > Also, some of code and commit messages I've read seem to indicate even if > tcpdump could show me the VLAN ID, I wouldn't necessarily get any of this > traffic unless eth0 is in promisc mode. > > My main goal here is to be able to bridge eth0 to another device and ensure > that that device can see all the tagged traffic that comes in eth0. eth0 is > plugged into a Cisco switch and is a trunk port. Bridging + vlans has some limitations (being worked on at present IIRC) in Linux kernel. FYI -- Jeremy Jackson Coplanar Networks (519)489-4903 http://www.coplanar.net jerj@xxxxxxxxxxxx -- To unsubscribe from this list: send the line "unsubscribe linux-net" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
