hello, I am trying to install et/hdlc driver according to the documentation at http://www.etinc.com/linuxman.htm. I have 2 ACB-IV sealevel sync. serial cards on two suse linux 6.2(kernel 2.2.14) and I want to make a connection using these cards. in the "Running hdlccfg to Start the HDLC Subsystems" chapter of the document, it is written that: "Before running the configuration utility, you should create a line configuration file which represents the appropriate HDLC environment." so I changed the file as: device="hdlc0" protocol="cisco_hdlc" is this correct? and also the main problem I come across is when I type # hdlccfg ets0.cisco.cfg I see the line : "config file not found" both the file and hdlccfg is in the same directory (/usr/hdlc/utils) so what is the problem?how does hdlccfg works? hope you help. regards. - : send the line "unsubscribe linux-net" in the body of a message to majordomo@vger.kernel.org