Re: [PATCH v6 08/18] mtd: rawnand: Use the new ECC engine type enumeration

[Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>]

On Thu, 28 May 2020 13:31:03 +0200
Miquel Raynal <miquel.raynal@xxxxxxxxxxx> wrote:

> Mechanical switch from the legacy "mode" enumeration to the new
> "engine type" enumeration in drivers and board files.
> 
> The device tree parsing is also updated to return the new enumeration
> from the old strings.
> 
> Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>

I didn't check all the changes, but I'm fine with the approach

Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>

> diff --git a/include/linux/platform_data/mtd-davinci.h b/include/linux/platform_data/mtd-davinci.h
> index 3383101c233b..dd474dd44848 100644
> --- a/include/linux/platform_data/mtd-davinci.h
> +++ b/include/linux/platform_data/mtd-davinci.h
> @@ -60,16 +60,16 @@ struct davinci_nand_pdata {		/* platform_data */
>  	struct mtd_partition	*parts;
>  	unsigned		nr_parts;
>  
> -	/* none  == NAND_ECC_NONE (strongly *not* advised!!)
> -	 * soft  == NAND_ECC_SOFT
> -	 * else  == NAND_ECC_HW, according to ecc_bits
> +	/* none  == NAND_ECC_ENGINE_TYPE_NONE (strongly *not* advised!!)
> +	 * soft  == NAND_ECC_ENGINE_TYPE_SOFT
> +	 * else  == NAND_ECC_ENGINE_TYPE_ON_HOST, according to ecc_bits
>  	 *
>  	 * All DaVinci-family chips support 1-bit hardware ECC.
>  	 * Newer ones also support 4-bit ECC, but are awkward
>  	 * using it with large page chips.
>  	 */
> -	enum nand_ecc_mode	ecc_mode;
> -	enum nand_ecc_placement	ecc_placement;
> +	enum nand_ecc_engine_type engine_type;
> +	enum nand_ecc_placement ecc_placement;

Nitpick: if you want to use a space instead of tab, it should be done in
patch 3.

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/