Re: [PATCH v2 01/11] dt-bindings: spi: allow expressing DTR capability

[Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>]

On Thu, 27 Feb 2020 16:44:25 +0000
Mark Brown <broonie@xxxxxxxxxx> wrote:

> On Thu, Feb 27, 2020 at 05:40:31PM +0100, Geert Uytterhoeven wrote:
> > On Thu, Feb 27, 2020 at 5:28 PM Mark Brown <broonie@xxxxxxxxxx> wrote:  
> 
> > > It's what we do for other properties, and if this is anything like the
> > > other things adding extra wiring you can't assume that the ability to
> > > use the feature for TX implies RX.  
> 
> > Double Transfer Rate uses the same wire.  
> 
> But is it still on either the TX or RX signals?

There's no separate RX/TX pins when using xD-xD-xD modes (pins switch
from RX to TX) and I doubt DTR will ever be used on single SPI.

> 
> > But as you sample at both the rising and the falling edges of the clock, this
> > makes the cpha setting meaningless for such transfers, I think ;-)  
> 
> Might affect what the first bit is possibly?
> 
> > However, as the future may bring us QDR, perhaps this should not be a
> > boolean flag, but an integer value?
> > Cfr. spi-tx-bus-width vs. the original spi-tx-dual/spi-tx-quad proposal.  
> 
> > What would be a good name (as we only need one)? spi-data-phases?  
> 
> Sounds reasonable, apart from the increasingly vague connection with
> something that's recognizably SPI :P

Or maybe we should refrain from adding a new flag and wait a bit to see
if this DTR mode is actually used for regular SPI transfers (AKA not
spi-mem) :-).

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/