On Tue, 21 May 2019 10:43:35 +0200 Sascha Hauer <s.hauer@xxxxxxxxxxxxxx> wrote: > memorg->ntargets is initialized with '1'. It should be initialized with > the maxchips argument from nand_scan() instead. Otherwise multi chip > support errors out on the secondary chip selects when trying to call > nand_reset() on them: > > WARNING: CPU: 0 PID: 1 at drivers/mtd/nand/raw/internals.h:114 > nand_reset_op+0x194/0x1c4 > > With this memorg->ntargets is initialized with the maximum number of > chip selects supported by the driver. After having detected the number > of actually connected chips memory->ntargets is updated with that > number. > > Fixes: 32813e288414 ("mtd: rawnand: Get rid of chip->numchips") > Signed-off-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx> Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx> And thanks for the fix. Boris > --- > > Changes since v1: > > - initialize memorg->ntargets directly in nand_scan_ident() rather than > passing it as argument to nand_detect() > - Fix Fixes: committish, leading '3' was missing > > drivers/mtd/nand/raw/nand_base.c | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c > index 7db0f04cf52b..a8a7e81be710 100644 > --- a/drivers/mtd/nand/raw/nand_base.c > +++ b/drivers/mtd/nand/raw/nand_base.c > @@ -4638,7 +4638,6 @@ static int nand_detect(struct nand_chip *chip, struct nand_flash_dev *type) > memorg = nanddev_get_memorg(&chip->base); > memorg->planes_per_lun = 1; > memorg->luns_per_target = 1; > - memorg->ntargets = 1; > > /* > * Reset the chip, required by some chips (e.g. Micron MT29FxGxxxxx) > @@ -5003,6 +5002,8 @@ static int nand_scan_ident(struct nand_chip *chip, unsigned int maxchips, > if (ret) > return ret; > > + memorg->ntargets = maxchips; > + > /* Read the flash type */ > ret = nand_detect(chip, table); > if (ret) { ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/