Re: [PATCH 1/2] dt-bindings: mtd: brcmnand: Make nand-ecc-strength and nand-ecc-step-size optional

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

Hi Kamal,

Kamal Dasu <kdasu.kdev@xxxxxxxxx> wrote on Fri, 17 May 2019 14:29:54
-0400:

> nand-ecc-strength and nand-ecc-step-size can be made optional as
> brcmanand driver can support using the nand_base driver detected

      ^ typo                             raw NAND layer

> values.
> 
> Signed-off-by: Kamal Dasu <kdasu.kdev@xxxxxxxxx>
> ---

With this addressed:

Reviewed-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>

>  Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> index bcda1df..29feaba 100644
> --- a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> +++ b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> @@ -101,10 +101,10 @@ Required properties:
>                                number (e.g., 0, 1, 2, etc.)
>  - #address-cells            : see partition.txt
>  - #size-cells               : see partition.txt
> -- nand-ecc-strength         : see nand.txt
> -- nand-ecc-step-size        : must be 512 or 1024. See nand.txt
>  
>  Optional properties:
> +- nand-ecc-strength         : see nand.txt
> +- nand-ecc-step-size        : must be 512 or 1024. See nand.txt
>  - nand-on-flash-bbt         : boolean, to enable the on-flash BBT for this
>                                chip-select. See nand.txt
>  - brcm,nand-oob-sector-size : integer, to denote the spare area sector size


Thanks,
Miquèl

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/