Re: [PATCH v1] mtd: rawnand: Add Macronix NAND read retry support

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

Hello,

Thomas Petazzoni <thomas.petazzoni@xxxxxxxxxxx> wrote on Fri, 10 May
2019 15:37:04 +0200:

> Hello,
> 
> Some purely cosmetic suggestions below.
> 
> On Fri, 10 May 2019 15:41:02 +0800
> Mason Yang <masonccyang@xxxxxxxxxxx> wrote:
> 
> > +	if (ret)
> > +		pr_err("set feature failed to read retry moded:%d\n", mode);    
> 
> I don't know what is the policy in the MTD/NAND subsystem, but
> shouldn't you be using dev_err() instead of pr_err() here to have a
> nice prefix for the message ?
> 
> 		dev_err(&nand_to_mtd(chip)->dev, "set feature ..", mode);

Actually, no, manufacturer initializations happens in
nand_scan_tail() which runs before mtd_device_register(). At this
point, mtd->dev is not yet populated so dev_err() cannot be used. You
should keep a pr_err().


Thanks,
Miquèl

______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/