On 11/12/2018 12:32:40+0000, Tudor.Ambarus@xxxxxxxxxxxxx wrote: > Hi, Alexandre, > > On 12/10/2018 11:35 PM, Alexandre Belloni wrote: > > Hi, > > > > On 10/12/2018 17:15:29+0000, Tudor.Ambarus@xxxxxxxxxxxxx wrote: > >> From: Cyrille Pitchen <cyrille.pitchen@xxxxxxxxxxxxx> > >> > >> This patch configures the QSPI0 controller pin muxing and declares > >> a jedec,spi-nor memory. > >> > >> sama5d2 Xplained RevB and RevC use the Macronix MX25L25673G flash > >> memory which advertises a maximum frequency of 80MHz for Quad IO > >> Fast Read. Set the spi-max-frequency to 80MHz knowing that actually > >> the QSPI drver will set the SPI bus clock to 166MHz / 3 = 55.3MHz. > >> > >> Signed-off-by: Cyrille Pitchen <cyrille.pitchen@xxxxxxxxxxxxx> > >> [tudor.ambarus@xxxxxxxxxxxxx: > >> - drop partitions, > >> - add spi-rx/tx-bus-width > >> - change spi-max-frequency to match the 80MHz limit advertised by > >> MX25L25673G for Quad IO Fast Read, > >> - reword commit message and subject.] > >> Signed-off-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxxxxx> > >> --- > >> arch/arm/boot/dts/at91-sama5d2_xplained.dts | 31 +++++++++++++++++++++++++++++ > >> 1 file changed, 31 insertions(+) > >> > >> diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts b/arch/arm/boot/dts/at91-sama5d2_xplained.dts > >> index 518e2b095ccf..171bc82cfbbf 100644 > >> --- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts > >> +++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts > >> @@ -108,6 +108,21 @@ > >> }; > >> > >> apb { > >> + qspi0: spi@f0020000 { > >> + pinctrl-names = "default"; > >> + pinctrl-0 = <&pinctrl_qspi0_default>; > >> + /* status = "okay"; */ /* conflict with sdmmc1 */ > > > > Isn't that conflicting then because I think the default is okay. > qspi0 is disabled in sama5d2.dtsi. > Ok, then maybe that comment is not necessary at all. -- Alexandre Belloni, Bootlin Embedded Linux and Kernel engineering https://bootlin.com ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/