[PATCH v5 1/3] mtd: spi-nor: Add the SNOR_F_4B_OPCODES flag

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Some flash_info entries have the SPI_NOR_4B_OPCODES flag set to let the
core know that the flash supports 4B opcode. While this solution works
fine for id-based caps detection, it doesn't work that well when relying
on SFDP-based caps detection. Let's add an SNOR_F_4B_OPCODES flag so
that the SFDP parsing code can set it when appropriate.

Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx>
---
Changes in v5:
- Cosmetic changes

Changes in v4:
- Set SNOR_F_4B_OPCODES flag outside of the if (mtd->size > 0x1000000)
  block
- Do not set SNOR_F_4B_OPCODES when BFPT_DWORD1_ADDRESS_BYTES_4_ONLY,
  because 4byte only does not imply 4B opcodes are supported

Changes in v3:
- Clear SNOR_F_4B_OPCODES flag when SFDP fails
- Add Alexandre R-b

Changes in v2:
- Fix the commit message
- Fix the ->addr_width check
- Add a comma at the end of the SNOR_F_4B_OPCODES definition
---
 drivers/mtd/spi-nor/spi-nor.c | 21 +++++++++++----------
 include/linux/mtd/spi-nor.h   |  1 +
 2 files changed, 12 insertions(+), 10 deletions(-)

diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
index 8f07430ffffa..bea122e0d731 100644
--- a/drivers/mtd/spi-nor/spi-nor.c
+++ b/drivers/mtd/spi-nor/spi-nor.c
@@ -3272,6 +3272,7 @@ static int spi_nor_init_params(struct spi_nor *nor,
 
 		if (spi_nor_parse_sfdp(nor, &sfdp_params)) {
 			nor->addr_width = 0;
+			nor->flags &= ~SNOR_F_4B_OPCODES;
 			/* restore previous erase map */
 			memcpy(&nor->erase_map, &prev_map,
 			       sizeof(nor->erase_map));
@@ -3572,9 +3573,7 @@ static int spi_nor_init(struct spi_nor *nor)
 		}
 	}
 
-	if ((nor->addr_width == 4) &&
-	    (JEDEC_MFR(nor->info) != SNOR_MFR_SPANSION) &&
-	    !(nor->info->flags & SPI_NOR_4B_OPCODES)) {
+	if (nor->addr_width == 4 && !(nor->flags & SNOR_F_4B_OPCODES)) {
 		/*
 		 * If the RESET# pin isn't hooked up properly, or the system
 		 * otherwise doesn't perform a reset command in the boot
@@ -3606,10 +3605,8 @@ static void spi_nor_resume(struct mtd_info *mtd)
 void spi_nor_restore(struct spi_nor *nor)
 {
 	/* restore the addressing mode */
-	if ((nor->addr_width == 4) &&
-	    (JEDEC_MFR(nor->info) != SNOR_MFR_SPANSION) &&
-	    !(nor->info->flags & SPI_NOR_4B_OPCODES) &&
-	    (nor->flags & SNOR_F_BROKEN_RESET))
+	if (nor->addr_width == 4 && !(nor->flags & SNOR_F_4B_OPCODES) &&
+	    nor->flags & SNOR_F_BROKEN_RESET)
 		set_4byte(nor, nor->info, 0);
 }
 EXPORT_SYMBOL_GPL(spi_nor_restore);
@@ -3765,13 +3762,17 @@ int spi_nor_scan(struct spi_nor *nor, const char *name,
 	} else if (mtd->size > 0x1000000) {
 		/* enable 4-byte addressing if the device exceeds 16MiB */
 		nor->addr_width = 4;
-		if (JEDEC_MFR(info) == SNOR_MFR_SPANSION ||
-		    info->flags & SPI_NOR_4B_OPCODES)
-			spi_nor_set_4byte_opcodes(nor, info);
 	} else {
 		nor->addr_width = 3;
 	}
 
+	if (info->flags & SPI_NOR_4B_OPCODES ||
+	    (JEDEC_MFR(info) == SNOR_MFR_SPANSION && mtd->size > SZ_16M))
+		nor->flags |= SNOR_F_4B_OPCODES;
+
+	if (nor->addr_width == 4 && nor->flags & SNOR_F_4B_OPCODES)
+		spi_nor_set_4byte_opcodes(nor, info);
+
 	if (nor->addr_width > SPI_NOR_MAX_ADDR_WIDTH) {
 		dev_err(dev, "address width is too large: %u\n",
 			nor->addr_width);
diff --git a/include/linux/mtd/spi-nor.h b/include/linux/mtd/spi-nor.h
index 8b1acf68b7ac..981d628305a2 100644
--- a/include/linux/mtd/spi-nor.h
+++ b/include/linux/mtd/spi-nor.h
@@ -237,6 +237,7 @@ enum spi_nor_option_flags {
 	SNOR_F_READY_XSR_RDY	= BIT(4),
 	SNOR_F_USE_CLSR		= BIT(5),
 	SNOR_F_BROKEN_RESET	= BIT(6),
+	SNOR_F_4B_OPCODES	= BIT(7),
 };
 
 /**
-- 
2.17.1


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/



[Index of Archives]     [LARTC]     [Bugtraq]     [Yosemite Forum]     [Photo]

  Powered by Linux