This is required for OpenWrt Project to result the flash write issue as below patche. <https://git.openwrt.org/?p=openwrt/openwrt.git;a=commitdiff;h=ddc11c3932c7b7b7df7d5fbd48f207e77619eaa7> So change to use chip_good() instead of chip_ready(). Signed-off-by: Tokunori Ikegami <ikegami@xxxxxxxxxxxxxxxxxxxx> Cc: Fabio Bettoni <fbettoni@xxxxxxxxx> Cc: Chris Packham <chris.packham@xxxxxxxxxxxxxxxxxxx> Cc: Joakim Tjernlund <Joakim.Tjernlund@xxxxxxxxxxxx> Cc: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx> Cc: linux-mtd@xxxxxxxxxxxxxxxxxxx --- drivers/mtd/chips/cfi_cmdset_0002.c | 18 ++++++++++++------ 1 file changed, 12 insertions(+), 6 deletions(-) diff --git a/drivers/mtd/chips/cfi_cmdset_0002.c b/drivers/mtd/chips/cfi_cmdset_0002.c index 72428b6bfc47..251c9e1675bd 100644 --- a/drivers/mtd/chips/cfi_cmdset_0002.c +++ b/drivers/mtd/chips/cfi_cmdset_0002.c @@ -1627,31 +1627,37 @@ static int __xipram do_write_oneword(struct map_info *map, struct flchip *chip, continue; } - if (time_after(jiffies, timeo) && !chip_ready(map, adr)){ + if (chip_good(map, adr, datum)) + break; + + if (time_after(jiffies, timeo)){ xip_enable(map, chip, adr); printk(KERN_WARNING "MTD %s(): software timeout\n", __func__); xip_disable(map, chip, adr); + ret = -EIO; break; } - if (chip_ready(map, adr)) - break; - /* Latency issues. Drop the lock, wait a while and retry */ UDELAY(map, chip, adr, 1); } + /* Did we succeed? */ - if (!chip_good(map, adr, datum)) { + if (ret) { /* reset on all failures. */ map_write(map, CMD(0xF0), chip->start); /* FIXME - should have reset delay before continuing */ - if (++retry_cnt <= MAX_RETRIES) + if (++retry_cnt <= MAX_RETRIES) { + ret = 0; goto retry; + } ret = -EIO; } + xip_enable(map, chip, adr); + op_done: if (mode == FL_OTP_WRITE) otp_exit(map, chip, adr, map_bankwidth(map)); -- 2.18.0 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/