Hi Boris On Wed, Oct 3, 2018 at 5:17 PM Boris Brezillon <boris.brezillon@xxxxxxxxxxx> wrote: > > On Wed, 3 Oct 2018 17:11:14 +0200 > Boris Brezillon <boris.brezillon@xxxxxxxxxxx> wrote: > > > Hi Ricardo, > > > > On Mon, 1 Oct 2018 14:43:49 +0200 > > Ricardo Ribalda Delgado <ricardo.ribalda@xxxxxxxxx> wrote: > > > > > @@ -248,14 +252,19 @@ static int gpio_flash_probe(struct platform_device *pdev) > > > > > > i = 0; > > > do { > > > - if (devm_gpio_request(&pdev->dev, state->gpio_addrs[i], > > > - DRIVER_NAME)) { > > > + unsigned int *gpio_id = (unsigned int *)gpios->start; > > > + > > > + if (devm_gpio_request_one(&pdev->dev, gpio_id[i], GPIOD_OUT_LOW, > > > + DRIVER_NAME)) { > > > dev_err(&pdev->dev, "failed to request gpio %d\n", > > > - state->gpio_addrs[i]); > > > + gpio_id[i]); > > > return -EBUSY; > > > } > > > - gpio_direction_output(state->gpio_addrs[i], 0); > > > - } while (++i < state->gpio_count); > > > + > > > + state->gpios->desc[i] = gpio_to_desc(gpio_id[i]); > > > + if (!state->gpios->desc[i]) > > > + return -EINVAL; > > > + } while (++i < state->gpios->ndescs); > > > > Actually, I was thinking about using devm_gpiod_get_array() here and > > defining a gpio lookup table in the board file registering the device. > > This way, adding support for DT based parsing is transparent. > > It's actually easier than I thought since no one is registering such a > device, so all you have to do is call devm_gpiod_get_array() and have a > struct gpio_descs pointer in struct async_state. That is what I do in patch 8/8 for DT based parsing. I am am doing the gpio_to_desc and other to maintain compatibility with old platform board files (in and out tree). I think is important to maintain that compatibility, but you decide ;) Cheers -- Ricardo Ribalda ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/