Hello, The first optionbased on lpr -P Laserprinter command didnot work The second option based on cat command did not produce any files in tmp. Any suggestions? Thanks, Vedran On Sat, Nov 20, 2010 at 1:49 PM, Ivan Baldo <ibaldo@xxxxxxxxxxxxx> wrote: > Hello. > Strange then... it seems everything is configured right but your specific > application doesn't work. > Have you waited more than 20 seconds? > Also, you may try putting this in dosemu.conf: > $_lpt1 = "lpr -P Laserprinter" > $_lpt2 = "lpr -P Laserprinter" > $_lpt3 = "lpr -P Laserprinter" > This is just in case that it uses another port. > > Another thing you can try: > $_lpt1 = "cat >>/tmp/dosemu.lpt1" > $_lpt2 = "cat >>/tmp/dosemu.lpt2" > $_lpt3 = "cat >>/tmp/dosemu.lpt3" > Then try printing from the program and look at those files in /tmp to see > what they contain. > > Hope this helps! > Bye. > > > > El 19/11/10 03:46, Vedran Vucic escribiÃ: >> >> Hello, >> >> When I do command: dir>PRN it prints a list of subfolders. >> >> My DOS application prints to PRN. Any advise? >> >> Best wishes, >> >> Veki >> >> On Fri, Nov 19, 2010 at 1:14 AM, Ivan Baldo<ibaldo@xxxxxxxxxxxxx> wrote: >> >>> >>> Hello. >>> Your boot.log looks right! >>> The DOS application prints to LPT1 or PRN? Maybe it prints to LPT2 or >>> LPT3 in which case you can configure them in dosemu.conf to be the same >>> printer. >>> If you execute under DOS the command "dir>PRN" does it print anything? >>> HTH. >>> Bye. >>> >>> >>> >>> El 18/11/10 22:02, Vedran Vucic escribiÃ: >>> >>>> >>>> Hello, >>>> >>>> Please check this: >>>> http://pastebin.ca/1995937 >>>> >>>> Thanks, >>>> >>>> Veki >>>> >>>> On Fri, Nov 19, 2010 at 12:52 AM, Ivan Baldo<ibaldo@xxxxxxxxxxxxx> >>>> wrote: >>>> >>>> >>>>> >>>>> Hello. >>>>> The config file seems correct. >>>>> But maybe DOSEmu isn't reading that file but another. >>>>> Please post the file boot.log (usually in ~/.dosemu/boot.log). >>>>> Thanks!!! >>>>> >>>>> >>>>> El 18/11/10 21:18, Vedran Vucic escribiÃ: >>>>> >>>>> >>>>>> >>>>>> Hello, >>>>>> >>>>>> When I want to print from my DOS application I cannot print on my USB >>>>>> HP LP1020 printer. My printer is named Laserprinter in my cups >>>>>> configuration. When I print from terminal using command >>>>>> lpr -P Laserprinter nameoffile >>>>>> it works well. >>>>>> You can find my dosemu.conf on this link: >>>>>> http://pastebin.ca/1995898 >>>>>> >>>>>> Please advise. >>>>>> >>>>>> Thanks, >>>>>> >>>>>> Veki > > -- > Ivan Baldo - ibaldo@xxxxxxxxxxxxx - http://ibaldo.codigolibre.net/ > From Montevideo, Uruguay, at the south of South America. > Freelance programmer and GNU/Linux system administrator, hire me! > Alternatives: ibaldo@xxxxxxxxxxxxxxx - http://go.to/ibaldo > > -- To unsubscribe from this list: send the line "unsubscribe linux-msdos" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
